My microHD has decided to no longer properly work. When testing it this is what I have found
22K is stuck on, will not switch off. Verified with a new 22k switch and also with one of those satellite meters that have LEDs for 22K on/off and for 13/18 volts. Voltage is correct and works properly at the LNB. Also verified the switch works by testing it on another receiver (openbox s10). Diseqc 1.2 and USALS no longer works, seems to be no longer sending out any commands. Diseqc 1.0 is the same way testing on a known working switch.
It does scan and will receive a satellite, as long as it is stationary and no 22K tone is needed. So for a stationary dish it works fine
I have done a factory reset, reflashed the firmware to the latest factory version, checked for correct latitude and longitude, but it all points to a box that has just about stopped working.
Is there anything internal I can test/check/replace that may have gone out that controls the diseqc tone bursts to get the receiver back working like it used to?
22K is stuck on, will not switch off. Verified with a new 22k switch and also with one of those satellite meters that have LEDs for 22K on/off and for 13/18 volts. Voltage is correct and works properly at the LNB. Also verified the switch works by testing it on another receiver (openbox s10). Diseqc 1.2 and USALS no longer works, seems to be no longer sending out any commands. Diseqc 1.0 is the same way testing on a known working switch.
It does scan and will receive a satellite, as long as it is stationary and no 22K tone is needed. So for a stationary dish it works fine
I have done a factory reset, reflashed the firmware to the latest factory version, checked for correct latitude and longitude, but it all points to a box that has just about stopped working.
Is there anything internal I can test/check/replace that may have gone out that controls the diseqc tone bursts to get the receiver back working like it used to?