"moving" and timers

[Derwin0]

I'm looking to have Dish replace my 942 with a 622 because of the MPEG2 HD channels going away.
In order to have dish swap it out without having to do a contract, I have to have an installer do it. For some reason a self-install requires a contract.

Currently my service address is in Franklin County, allowing me to get Washington HD locals in addition to the Harrisburg locals that my real/billing address gives me.

I have several timers set to the Washington HD locals. With summer in full swing, I won't miss anything recording, but I'd hate to lose the timers.
If I "move" back to my billing address, will the timers be deleted? Or preferably just be incorrect times and then go back to normal when I "move" back after the upgrade?

 

[eddieras]

ever figure this out? btw - love the old flames logo!

 

[Derwin0]

ever figure this out?

No, not gotten any answers on it.
I'll probably have to just chance it, and write down all my timers just in case.

btw - love the old flames logo!

thanks, I grew up with the old Atlanta Flames as a kid. Was pissed when they were sold out from under us to someone in Calgary.

 

[eddieras]

and that calgary version never cut it for me.... at least the honored the original flames with the A...

 

[jesch3]

with the new rcvr you are going to have to reset all of your timers anyway. the old timers go with the old rcvr.

 

[Derwin0]

with the new rcvr you are going to have to reset all of your timers anyway. the old timers go with the old rcvr.

The receiver with the timers is a 622 and not being replaced. I probably should have been more clear in my posting about that.

I have a 942 in the kid's playroom that will be the one being replaced. I personally don't care about the 20 different timers that it has for Spongbob.