Hi all,
I had recently upgraded from HD6000 to DVR942. I never had any problems with HD6000. As part of upgrade, replaced dish 500 legacly dual lnb with dishpro dual lnb, installed microyal dp34 switch, and pulled extra cable to the receiver. Hooked up everything togehter, run check switch, and everything was ok (both tuners get both sats, strength 90).
The problem now is that after some hours of inactivity the receiver looses the signal, and tries to aquire it again. Reaquiring takes anywhere from 1 min to 15 min, as it tries, freeses, and reboots in a loop. Check switch ALWAYS passes fine. However I noticed something: if I break out of signal aquisition loop sometimes it shows that it locks wrong sat (119 instead of 110).
Any ideas? I thought about re-aiming, but how could aim become off by period of inactivity? Besides old receiver had no problems. Could it be LNB, switch or receiver that misbehaves occasionally ?
I had recently upgraded from HD6000 to DVR942. I never had any problems with HD6000. As part of upgrade, replaced dish 500 legacly dual lnb with dishpro dual lnb, installed microyal dp34 switch, and pulled extra cable to the receiver. Hooked up everything togehter, run check switch, and everything was ok (both tuners get both sats, strength 90).
The problem now is that after some hours of inactivity the receiver looses the signal, and tries to aquire it again. Reaquiring takes anywhere from 1 min to 15 min, as it tries, freeses, and reboots in a loop. Check switch ALWAYS passes fine. However I noticed something: if I break out of signal aquisition loop sometimes it shows that it locks wrong sat (119 instead of 110).
Any ideas? I thought about re-aiming, but how could aim become off by period of inactivity? Besides old receiver had no problems. Could it be LNB, switch or receiver that misbehaves occasionally ?