Receiver motor control

My experience with motors has been varied! Both the single and dual button SG2100 is problematic, when switching between receivers it tends to loose its zero reference. Which
forces you to do a manual reset to get back to operational status. Also if you power down
the receiver while the dish is moving you will also loose zero reference point. The motor works well, you just have to be aware of the issues.
Now the Stab HH-90 was the best Ive used and does not have any issues Iam aware of.
The HH-100 and HH-120 their gear is spring loaded so in high winds you will have intermittent signal. Usals works great with just about any receiver, but Diseqc 1.2 is a whole
nother story. The SatCotrol motor has a built in switch that automatically moves the dish six
degrees offset when you switch to port 2 or the second lnbf. Which is a pain if you use the
Invacom lnbf QPH-31.

I would recommend the Mercury II with a Sadoun Powertech Motor (i.e. DG280 or DG380)

If your dish has the 1 5/8" ID bracket, then get the 42 ( 1 5/8") shaft on the motor.
If your dish has the U-Bolt bracket, then get the 50 ( 2") shaft on the motor is recommended.

I've got a Fortec with the DG240 and have no issues what so ever.

You are