I have a Dish 1000.2 Eastern Arc residential Dish Network dish with 2 coax runs from it. The coax runs about 25 feet to a roof closet where the previous tenant left fibre. I used one fibre for an OTA antenna with a pair of Televes devices that were also left behind.
I would like to use another run for the Dish feed. That fibre is about 250 feet long and terminates in our rack. Inside our rack I have two daisy chained DPP44 multiswitches feeding eight VIP211z tuners.
I would like to use a set of the F-SattGalaxy-TX/RX-3 from Thor Broadcast. The pre-sales engineer is asking "verify the Voltages of which LNB output goes to which port on the SattGalaxy"
Does anyone have a similar setup, another idea, or the voltages?
I would like to use another run for the Dish feed. That fibre is about 250 feet long and terminates in our rack. Inside our rack I have two daisy chained DPP44 multiswitches feeding eight VIP211z tuners.
I would like to use a set of the F-SattGalaxy-TX/RX-3 from Thor Broadcast. The pre-sales engineer is asking "verify the Voltages of which LNB output goes to which port on the SattGalaxy"
Does anyone have a similar setup, another idea, or the voltages?
