Can a Zinwell 4x8 fail in such a way that only one output port (#3) is bad? I have a Slimline, the aformentioned Zinwell & two Hr20-700's & two D10-200's (I used to have an older RCA for the 7th tuner but when I started to get this problem I just disconnected it)
Now both of the D10's do not have the Slimline nor AT-9 as an option, so I have them both set to the Round 1-LNB Dish. However, when I connect either D10 to output port 3 then I only get the even transponders & all of the odd read 0. If one of the LNB's was going out on my Slimline, then should either of my HR20's see that problem too?
Now both of the D10's do not have the Slimline nor AT-9 as an option, so I have them both set to the Round 1-LNB Dish. However, when I connect either D10 to output port 3 then I only get the even transponders & all of the odd read 0. If one of the LNB's was going out on my Slimline, then should either of my HR20's see that problem too?