Search results for query: *

So you assume all zillion people at Dish Network know why the upper level folks decided to do anything....and because they can't answer your question they are dishonest? And a 3 minute program guide update is hurting you? Get a life.

If your receiver (722) did have its own volume control, you would then need some device to measure the pre amp signal you are messing with at the 722. If it's not high enough you lose frequencies at your amp, laptop, or what ever. If too high you will get distortion. The preamp signal you are...

As was stated before, you might have a short in the cable between the 301 and the dish. If there is one, you should be able to hold the receiver to your ear and hear a buzzing. If you disconect the cable from the dish and the buzz goes away, that is your problem. The receiver is trying to...

Regardless of any other issues, you should turn your receiver off at night (both green and blue lights ..1&2) Out of the factory your 722 is set to recieve program information every morning at 3 a.m.. Your receiver needs this info to know what it is receiving. I have been installing dish for...

Why not just go to a dish retailer or ebay or stop an installer and buy a seperator for a couple of bucks?

I've had my 612 for a month now and have same "jerky" problems while watching my football games I have previously recorded. I hope it is sotware related and will get fixed through download. I have been a dish customer and installer for 6 years and realize it is a complete roll of the dice to...

Very possibly a loose fitting or a small piece of shield braid inside the fitting that was shorting it out and causing problem. Maybe when you wiggled it it got better. These kind of problems are impossible to deduce over the phone. Csrs will replace receivers rather that ask you to check the...

Did your installer use diplexers to combine and then split out the tv2 output from the 322 to the tv2 set? If so just put a splitter after the output from the 2nd diplexer (the one not behind the 322) and run to both tv2s. You should not need to amp it up, the tv2 output is pretty strong on...

FYI in case you did not understand..You are trying to use a "twin" in the dish 500 not a "dual" The twin is trying to check switch thru the dp44 which is also checking switch. The advice given was to use a "dual" which is a single eye lnb. you can use a dual with 2 output connectors or a single...

I have been an Braves fan since the mid 50's (Hank was my man when every other kid loved Mickey) and I have finially given up. It's MLB itself that has screwed this up. I watch on the internet only. I will not endure Joe Morgan or Rick Sutcliff if my Bravos happen to be ESPN Sun. or Wed...

Be aware that you will only get true Hd on that second tv if it is fed with component or hdmi cable. It is unrealistic for a company (DNW) to expect any installation to work that way and supply the proper cable to run 40 to 100 feet in component (+ 2 audio) or hdmi. Your best bet is to keep...

previous post is correct, any bad connection can cause that check switch result, receiver & seperator might be fine. Lnb could be bad also.

Why do you need a seperator? The seperator is ONLY for combining input 1 & 2 on a dual tuner, so that both can communicate with the dish using the same single cable.

Are you west or east of the river? East gets Tulsa locals which are so so in standard but hard to get at all in HD there. They are not on 129 though. The Okc spot beam is strong there but the zip code decides that you get Tulsa. Some folks give a 74601 address but have it installed out East...

Churn Churn happens when customers quit. Customers quit because they don't feel loyal to the company. Most folks don't have HD and don't care how many channels are out there. They just feel crapped on when they spend 30 minutes on the phone with someone who is ignorant of how their system...

As stated in earlier reply, you need to have the antenna(s) hooked up to both receivers. Then run scan for locals. In the middle of a busy install I have ran the scan but got off doing something else and not selected "save" after the scan results. If you don't do this soon after the scan, the...

If you don't have a HD tv in the garage, then possibly make tv2 in out there, one cable to tv, the other as an extension from the tv2 uhf antenna port with the actual antenna mounted in the garage. I have extended the antenna as much as 100 ft before with no problem. You will still get your HD...

Not strange, being disconnected from the actual satellite feed makes it lose its memory so to speak. Hook it up, plug it in, and turn it off with the tv still on and you should see a download on the screen. Another related RV problem that happens is when the receiver is plugged in to power in...

local retailer needs skilled, experienced, & honest Dish Network installer in north central Oklahoma. I've been doing it here for 4 years and need someone to take up some slack for me. Basically you would be working out of Stillwater, Ok.

I'm not in the FSN Mw, I'm in the FSN SW, and like I said, it has never happened before.

Cards blacked out on espn in Oklahoma I have never seen this before. I understood it when xtra innings blocked out the Cardinals..."Hey honey, let's not watch the Cards on tv, lets just drive to S.L. tonight, it's only an 8 hour drive and besides, Missouri touches Oklahoma, so it's right in...

put a quad in the dish 1000 (replacing the dpp twin) run 1 coax to the 501, 2 coax to the 721 (ditch the seperator) and put a dp 21 switch between the 4th quad output and the dp single (129) and run that coax to the 211. dp21 is 19-29 dollars ebay or however you can come up with one. do not...

What a tech is supposed to do is lock in 119, run all check switch, and the use the point dish screen set on 118 to further tune in 118.7. If you can turn up the volume to hear the point dish scream or have someone monitor your results to you on your cell phone, you could (without loosening any...

Absolute best thing is to locate and call a authorized Dish Network Dealer in the city you are moving to, and have them set up your dish mover. They will need only your last name and 16 digit DNW account #. If your are on DHPP the mover will be free. If you aren't on DHPP call dish and get on...

Has anyone used a 500+ or 1000+ yet? If so, what best signal strength did you come up with for 118.7 (on point dish screen)? I've got one coming up next week and could use a heads up. Thanks