Funny you ask.. When we first migraged to HD early on, they sent a contractor out to do the install. He just put up another D-500 and pointed it to 61.5. (the other D500 pointed at 110, 119 - from recall, I think) At the time all we had was a 211 for HD and 3 SD receivers. When my 622 arrived later it was nearly 3 months trying to get it installed (shortage of a DPP44 switch - is what I was told time and time again by Dish)
Finally, an installer came out to hook up the 622. Because of internal wiring logistics, it was impossible to run a second cable (for dual tuner) to the new 622. The DPP44 switch was impossible to locate anywhere. I got a run around for months about that. He left with no clue how to fix it. Fast Forward another 30 days.
Another local guy came out, looked and scratched his head, then got on the phone... Half hour later a DISH network supervisor pulls up in his truck. They took down the D500 pointing to 61.5 and put up the D1000.
That way, there was no switch involved for HD (the ellusive DPP44); A single cable to the 622 worked fine using separator and the other line from the D1000 fed the 211, now located in another room. The D500 feeds the two SD receivers and runs into a DP34 switch. I can't recall if SD receivers are using anything off the D1000. I don't think so.
So that's how it all happened over a 2 year period, 3 service calls and frustration to fill everyones appetite.
Now here we go again. What can I expect next? Should I call DISH or a local retailer/installer? Anyone know somebody that can fix this mess. I don't really care how it's done, just would like to get going on it.
Thanks