About 10 years ago I installed a Turbo HD dish with a DP Plus LNB to the eastern arc and have been receiving 72.7 and 61.5 all those years.
Recently I needed to move the dish to a light pole about 20' away and now can not get both satellites to work at the same time. I can get either to work, but not both.
In the beginning of time, I used to install Direct and Dish back when there was only one satellite for each company so small incremental dish movements are second nature.
I found a previous post entitled "1000.4 dish dpp lnb eastern arc" and tried aligning with aluminum foil over the outer feedhorns since a posted picture shows the center feedhorn to be the 72.7. Using that method, I didn't get a signal from any satellite. My direct single coax cable is connected to the #1 F connector. It's kind of confusing when the picture on the post show each LNB F connector has a specific satellite. I thought F connector #1 was the one to use with a single receiver.
Removing all foil and I can get 61.5 or 72.7 but not both. I have done multiple check switch tests and only one or the other satellite is displayed.
So 10 years later, what have I forgotten to do that was so easy back then?
View attachment 192547