Social Feed

sergei
Last reply · posted in C-BAND Satellite Discussion
I picked up a 8' dish last week and it has what appears to be H H mount made by Channel Master. Does anyone have any info on this setup, I can't find anything about it. I've been able to fix the motor and free up the mount but not sure how to adjust it, not like my other dishes which all use an actuator. I've been thinking about using it for a FTA setup.
9 Replies · 2186 views
sergei
Finally got around to putting up the channel master dish, still trying to figure out who might have made the HH mount. Any thoughts from anyone?
G
Sergei, I don't know anything about about your h-h mount, but I sure like that tractor. Just sold my 35hp Mahindra yesterday. I need one about the size of yours.
sergei
Sergei, I don't know anything about about your h-h mount, but I sure like that tractor. Just sold my 35hp Mahindra yesterday. I need one about the size of yours.
I when with the 2815 HST...great little tractor...it sure makes installing dishes a lot easier with the FEL.
sergei
Dish is up and working just great, tracking the arc perfectly, thank you for the info about it, already seen what happens when water gets into motor. Had to repair the main shaft gear and remove all the gears except for the sensor assembly because the main gear broke and most of the main shaft is rusted out and it took out the teeth on a smaller gear. So now I move it with the 920 and it just doesn't known where its fixed end limits are, I let the receiver set those.

Thanks again 1Captain for the added info.

Also I will agree with you on the performance, my dish next to it has a co-rotor on it and with just a plain c band feedhorn it has better readings across the satellites with both digital and analog channels....now to dig another hole for the 8' Zenith dish..and with this dish I think I've pushed the wife about as far as I can. Four dish seem to be her limit.
1
Hi Sergie I would set you're limits in the motor they are easy to do, an will let you know how. years ago had a customer with a DSR920 that took a lighting hit an his DSR receiver ran an Birdview dish to the far west an broke off the 3 mounting ears on the gear box that holds the motor to the steel plate, didn't relize it till hook up new motor an dish started running asap. the DSR was putting out voltage on the actuator wires when the receiver was power up.

Now to set the limits, 1st drive the dish to its west sat , then remove the motor, an the side cover, will notice a stop, 2 of them on each side of big roung gear (about 1/2" round bar welded to the back plate) then with a big scwer-driver turn the worm gear till almost to that bar (NOT on the bar just a little off it), an stop. now with a receiver or power supply run the motor west till it hits the west limit switch, (lower, grey ecentric an it is fixed can not move it is pressed on shaft). now reinstall the motor, west limit switch is set now.

now need to set east limit switch, the top grey ecentric is moveable, only has a small spring holding it down on teeth on the lower ecentric, if you take a small screw-diver an just lift it up will move an aline with the teeth on lower ecentric. now start moving the dish to the east till you start getting close to the east stop on the mount (agin round bar welded) then set the top limit to where it stops just before hitting the round bar stop, now you're east limit is set.

dive the dish back to the same position that you started from, hook up you're receiver an will be good to go to watch TV. Even on my motor drives that don't have limit switches on them I will try to mount a switch some how to get to trip just in case if any thing ever goes wrong, to keep from costing me time an money to fix them.
thomas34461usa
Finally got around to putting up the channel master dish, still trying to figure out who might have made the HH mount. Any thoughts from anyone?
Hi Sergei,
Looks like the Channel Master is a real nice dish! Would like to see more images of it. It sure helps to have a tractor too to help you erect it! ;) Good luck with it. I'm sure you will be happy with it.
Tom
:D
sergei
Here another picture when I installed my 10' Radex dish, I couldn't have installed my dish by myself without the tractor.
Scott Greczkowski
Staff member HERE TO HELP YOU! Cutting Edge
Last reply · posted in The Chit Chat Club
Sometimes a thread gets so many posts in it that is can cause issues for the server so that why today we introduce The Song Name Game Part 3!

So let the game continue!

The last song was added by Bobby who posted...

One Meat Ball - Andrews Sisters

CONTINUE ON AND HAVE FUN! WELCOME HOME TO SATELLITEGUYS.US!

Here are the original rules for the game as posted by WebbyDude back in 2006. http://www.satelliteguys.us/threads/68645-Song-Name-Game

Just name a song title and the band who performed it. The next person does the same thing, but needs to list a song title or band name which includes a word from the previous entry. Pick songs from any genre.

Example:

Long Live Rock and Roll -- Rainbow

Rainbow in the Dark -- Dio

Another example:

Ride the Lightning -- Metallica

Lightning Strikes -- Ozzy Osbourne


Get it?


An additional note: we all know that song titles, sometimes, use profane words. Because this is a family friendly website it is advised that you clean up that title up a bit. This is accomplished by using something like sh!t instead of the real word. Thanks....
68831 Replies · 2692275 views
  • Like
Reactions: c-spand
long_time_Dish
Rocks On The Road - Jethro Tull
  • Love
Reactions: dishstaller
dishstaller
Man On the Silver Mountain - Rainbow
EatMyVolts
Theme For An Imaginary Western - - Mountain
long_time_Dish
On The Western Skyline - Bruce Hornsby
H
SKYLINE Pigeon -Elton John
ewindowman
Lifetime Supporter
Last reply · posted in DISH Network Support Forum
Looks like dish is Bankrupt. Filling tomorrow Tuesday June 30th
507 Replies · 18944 views
JSheridan
AT&T runs First Net which was set up so first responders have a signal almost everywhere, which is the case around here and up and down the east coast when I've been traveling. In my experience T-Mobile has the fastest network but patchy coverage while Verizon has a slow network and also patchy coverage as well. We also have a iPhone on T-Mobile and one on Mobile-X which uses the Verizon network, so comparison is easy.
EarDemon
AT&T runs First Net which was set up so first responders have a signal almost everywhere, which is the case around here and up and down the east coast when I've been traveling. In my experience T-Mobile has the fastest network but patchy coverage while Verizon has a slow network and also patchy coverage as well. We also have a iPhone on T-Mobile and one on Mobile-X which uses the Verizon network, so comparison is easy.
I did a 2500 mile round trip road trip a few weeks ago, there were a handful of places where Verizon had service and I had nothing on FirstNet. Most notably in the backwoods of Kentucky and Tennessee. Those same places I had no service on T-Mobile either. In populated areas, like the Lexington metro and Knoxville metro AT&T not only had great coverage, better than Verizon and T-Mobile generally, they have n77 everywhere. I hit 1.2 Gbps or higher pretty much everywhere, beating out the other two. That is the exact opposite here back in Western NY. Very little n77 on AT&T here and T-Mobile always rockets to 1.5 Gbps or higher.

As far as I know, there is no AT&T tower in my town. The tower I connect to when I'm outside, no service indoors, is one about 4.5 miles north of me in a different town, I can barley latch on to band 12, not 14. It's LTE only but when near that tower I exceed 200 Mbps which is phenomenal for low band LTE, but T-Mobile and Verizon have mid band on the same tower, and i'm well over a gig.

I'm looking forward to the n14 conversion and deployment of n79/4.9 GHz. Since AT&T can't sell their home internet service in NY State, I don't expect big things from them besides the enhancements to FirstNet.
JSheridan
... Since AT&T can't sell their home internet service in NY State, I don't expect big things from them besides the enhancements to FirstNet.
We're in NY and we can now. We're an AT&T retailer and have been selling AT&T Internet Air for a few months. It's $35 a month if you're an AT&T post paid subscriber, $55 a month if you're not a subscriber.
Almighty1
We're in NY and we can now. We're an AT&T retailer and have been selling AT&T Internet Air for a few months. It's $35 a month if you're an AT&T post paid subscriber, $55 a month if you're not a subscriber.
The AT&T Internet that everyone has access to is AT&T WorldNet aka att.com which is the same backbone created in 1994 that is a joke. AT&T has 3 Internet tier 1 backbones. AT&T Global Network Services formerly IBM Global Network Services (prserv.net) and AT&T Emerging Network Services, formerly (CERFNet (California Educational and Research Foundation Network) that was part of NSFNet (National Science Foundation Network). AT&T WorldNet has always been a inferior and not the same quality as the other two which are highly respected.
  • Like
Reactions: charlesrshell
comfortably_numb
The AT&T Internet that everyone has access to is AT&T WorldNet aka att.com which is the same backbone created in 1994 that is a joke

JSheridan is referring to ATT's (relatively) new 5G cellular home internet.
  • Like
Reactions: charlesrshell
Almighty1
JSheridan is referring to ATT's (relatively) new 5G cellular home internet.
I know, that still will use AT&T's 1996 created backbone better known as AS 7018 which is the lower end. The other two are higher end under AS2685 & AS2686 & AS1740 & AS1838.
  • Like
Reactions: charlesrshell
Juan
JSheridan is referring to ATT's (relatively) new 5G cellular home internet.
Which connects to a backbone network
  • Like
Reactions: charlesrshell
comfortably_numb
Which connects to a backbone network

Fun fact.. the backhaul to the tower in Drexel, MO for both VZW and ATT is provided by CenturyLink
  • Like
Reactions: charlesrshell
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 7 views
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 18 views
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 9 views
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 18 views
BlackHitachi
Supporting Founder
Last reply · posted in Movie Talk
Since the Reds have there thread we should too!

Last watched Nine inch Nails
Next 3:10 to Yuma
5405 Replies · 512702 views
meStevo
Wild Horse Nine was fantastic.
dishstaller
Wild Horse Nine was fantastic.
Might have to check that out. Google describes it as a "dark comedy thriller".
long_time_Dish
Last night...

1794448622016.webp
  • Like
Reactions: dishstaller
osu1991
Veterans Day and business closed, so movie day and some tv on the patio. Watched several Chewed Up episodes on YouTube out on the patio until lunch time then came inside for the surround and movies.

Raise The Titanic (1980). Great musical score by John Barry of James Bond music fame.


View: https://youtu.be/KqWnM2xZ0gw?is=STWbRqNWrSZ1-z6-


Glenn Miller Story (1954). Great music


View: https://youtu.be/sMa-T71Az68?is=4YG3SQfWBjOG5305
Foxbat
After "VisionQuest" was over, I watched "Avengers: Infinity War" last night and "Avengers: Endgame" tonight.
osu1991
Xmas movies today. 😁. Die Hard and Die Hard 2
  • Haha
Reactions: long_time_Dish
osu1991
Pub Member / Supporter
Last reply · posted in The Chit Chat Club

The number-one US state for EV growth, according to the June 22 Yardi report?
Oklahoma.


:eek


It has no ZEV mandates and "minimal" incentives, Yardi says, but also has cheap electricity, high multi-car household rates (so, for example, a non-Lightning Ford F-150 pulls their trailers), and a consumer base willing to switch.
125 Replies · 1462 views
dishstaller
IF they had made the cyber truck more like a conventional truck, more would have bought it. There is a REASON trucks all have a very similar layout....it's what people want AND it serves the purposes those of us who have a truck needs.
  • Like
Reactions: osu1991
harshness
There is a REASON trucks all have a very similar layout....it's what people want AND it serves the purposes those of us who have a truck needs.
As it is, most consumers buy trucks as comfortable transportation rather than commercial utility. The Cybertruck approach to that goal was way out in left field. It turned out to be more of an austere sedan with awful daily-driver attributes (visibility, parking). The expectations regarding truck durability were dashed early on.
  • Like
Reactions: osu1991
osu1991


EV owners could face a new $130 annual federal fee as soon as December.

  • Congress is considering a new annual fee for electric vehicle owners to help fund road maintenance.
  • The proposed fee would start at $130 for EVs and $35 for plug-in hybrids, potentially increasing over time.
  • This fee aims to have EV drivers contribute to the Highway Trust Fund, which is primarily funded by gasoline taxes.
T
The truck is today's cadillac or buick
Foxbat
Never attempt to buy shrimp at a lumbago stand.
osu1991
  • Like
Reactions: Foxbat