Social Feed

F
Last reply · posted in DISH Network Support Forum
First post here, and looks like the place to get the proper solutions.

Here goes.

I have for the past 29 years been a BUD satellite man. That would be the "Big Ugly Dish" in the back yard.... BTW. it still works as I write this. The real true digital siginals... a 4DTV receiver. I have no complaints with the 4DTV. It's the rising cost of programming that is the reason I'm moving to Dish Network.

My son has Dish Network, and recently moved up to HD programming. He owned is own antenna and two receivers. The new D/N system gives him a new 1000.2 antenna, and a Dish DVR receiver. He kept one of the older 301 receivers.

He gave me the Dish 500 which has a DP twin LNBF (I think it is a twin, because he had one coax going to each 301 in two rooms), and the other JVC 301 receiver. I have installed the antenna, and setup the 301 in my den. I get a a great signal quality of 75, and can get several channels that are not in subscription by D/N.

I bought from a dealer in my area, a ViP 211k receiver, and about ready to install it.

Here's my plan.. I have two coax cables coming from the antenna LNBF(s) into the home. One coax runs into the attic and down to the family room, where the ViP 211 will be located. The other coax has already been hooked up to the JVC 301 in the den, and works.

Question:
Is this all I have to do...attach the RG-6 coax to the back (IN) on the ViP 211, and from what I have read here in some posts, is run a software download, and make a switch check..etc. And call Dish Network to have my account setup and receivers activated.

BTW: I don't have a HDTV...yet... mabye soon.
13 Replies · 2088 views
L
You'll need either 61.5 or 129...

depending on which, it may be just the start of your problems :)
F
depending on which, it may be just the start of your problems :)


From reading various posts here about HD programming, and what satellites that one must have to get HD. It would appear I need to make a change in the antenna. So, why don't I buy a Dish 500 from ebay with the hardware, and install it right next to the one I have now with a single LNB, and point it to one you mentioned. From reading other threads, it looks like I would need to change my DNpro twin out for a DN Plus twin LNBF. Which wouldn't be too hard to do since I setup the Dish 500 without any dealer/installer help.
osu1991
That will work just fine and probably yield better results than using the 1000,2 dish. IF Bella Vista is in the Tulsa Dma then you will not be able to get the HD locals from the Sat as only Tulsa sd locals are available until the 129 replacement satellite is launched. You will have to use an antenna to get Tulsa digital locals.
F
That will work just fine and probably yield better results than using the 1000,2 dish. IF Bella Vista is in the Tulsa Dma then you will not be able to get the HD locals from the Sat as only Tulsa sd locals are available until the 129 replacement satellite is launched. You will have to use an antenna to get Tulsa digital locals.


I have been getting the Tulsa channels for 20 or more years by a 30' pole with a Windgard Titan (the best) roof antenna. I can also get the TV stations in Joplin, Mo, and Fort Smith, Ar from the roof antenna. However, my problem comes Feb 17, 2008. I have two DTV converters boxes ready to install should the Dish 500 system not go well. But there is a "big" question mark regarding the digital signals for all the locals, due to the fact I live over 100 miles from Tulsa, and over 60 miles from the Joplin and Fort Smith stations towers. Majority of home owners here in the area are having a very difficult time getting these DTV converters to pick up the digital signals. Too many hills... no direct line sight to towers.
osu1991
Well starting in Aug the Tulsa stations will be cutting power to the analog transmitters to about 80-85 percent as they migrate their digital transmitters to the top of the broadcast towers. So your reception may be in limbo for a few months.
S
Had a BUD with 4DTV/HDD200. Was happy with it but for reasons you already know - gave it up. PQ is not as good on E* but not having to wait while moving SAT to SAT is not missed. Sound quality is better. Connections to HD equipment better. DVR is great. All and all I feel better off.
btw: Welcome to DISH.
jamieh1
Last reply · posted in DIRECTV Programming Forum
DIRECTV Stream/Internet added Ch 4105 SportsGrid
268 Replies · 38700 views
  • Like
Reactions: c-spand and KyL416
K
Now live:
4101 Yahoo! Sports Network
4121 DP World Tour
4195 F1 Channel
4196 MotoGP Channel
K
Now live:
4275 Law & Crime
4364 Military Makeover Channel
K
Game Show Central is now live on channel 4342
K
Now live:
4101 Yahoo! Sports Network
4121 DP World Tour
4195 F1 Channel
4196 MotoGP Channel
It only took them 41 days to announce it
  • Like
Reactions: Mr Tony
K
Now testing:
AyM Sports 3 USA
Best Bets TV powered by VSiN
CBS Sports Golazo Network
CBS Sports HQ
Judge Judy
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 2 views
dfergie
Staff member HERE TO HELP YOU!
Last reply · posted in What's Cooking?
We have a Breakfast and Dinner thread so... :)
Continuing from the Breakfast thread, found Cornbread mix so ...
Yellow Cornbread Mix
2 Hatch Green Chiles -diced
1 Egg
2/3 cup of milk
add to greased pan
Bake for 400f 20-25 minutes(From instructions)
now to put together and try... this to go with pinto beans...
5449 Replies · 336091 views
TRG
TRG
Club sandwich and corn chowder. Iced tea.
dfergie
Chili dog bowl, water… (homemade chili)
TRG
TRG
Leftover wanton soup and pork fried rice. Water.
dfergie
IMG_5955.webp

Sweet tea…
  • Like
Reactions: Bobby and TRG
TRG
TRG
Tuna salad sandwich on toasted honey whole wheat bread with a handful of kettle chips. Water.
  • Like
Reactions: Bobby
Scott Greczkowski
Staff member HERE TO HELP YOU! Cutting Edge
Last reply · posted in The Chit Chat Club
Sometimes a thread gets so many posts in it that is can cause issues for the server so that why today we introduce The Song Name Game Part 3!

So let the game continue!

The last song was added by Bobby who posted...

One Meat Ball - Andrews Sisters

CONTINUE ON AND HAVE FUN! WELCOME HOME TO SATELLITEGUYS.US!

Here are the original rules for the game as posted by WebbyDude back in 2006. http://www.satelliteguys.us/threads/68645-Song-Name-Game

Just name a song title and the band who performed it. The next person does the same thing, but needs to list a song title or band name which includes a word from the previous entry. Pick songs from any genre.

Example:

Long Live Rock and Roll -- Rainbow

Rainbow in the Dark -- Dio

Another example:

Ride the Lightning -- Metallica

Lightning Strikes -- Ozzy Osbourne


Get it?


An additional note: we all know that song titles, sometimes, use profane words. Because this is a family friendly website it is advised that you clean up that title up a bit. This is accomplished by using something like sh!t instead of the real word. Thanks....
68658 Replies · 2680237 views
  • Like
Reactions: c-spand
dishstaller
I Wanna Talk About Me - Toby Keith
  • Like
Reactions: RaiderPower
Bobby
98.6 - Keith
harshness
I'm Easy - Keith Carridine
gms49ers
It's Easy - Boston
RaiderPower
Take It Easy On Me - Little River Band
  • Like
Reactions: dishstaller
R
Last reply · posted in Computers and Gadgets
Lately my eight year old Dell laptop has been shutting off even when I have a full battery. I have had to keep it plugged up all the time to keep this from happening. Any idea what is causing this? I replaced the battery about three years ago.
2 Replies · 49 views
arlo
A recalibration might be needed. Even if it shows full, the individual cells may have become unbalaced. And the BMS chip in the battery reports false information to the pc.
Try this. Start it up in the bios/uefi and leave it there until the battery dies and it shuts off.
It might just keep running longer than in Windows. Or run for a short while and shut off.
If it's the first case. Probably just needs a balancing. If the latter, the pack might just be dead.
Not throwing stones but perhaps just a cheaply constructed battery with substandard cells. Could be.

Patience. Keep restarting it in bios/uefi until it won't fire up anymore.
Then plug the charger in and let it complete a full charge. And see what happens. If it's better.
Do the same thing one more time. Run it until it dies dead-dead. Then just let it charge, pc shut off.
When charged, it might be better. It might not be.

There are bench jigs that read the actual BMS and override it to let a tech manually monitor and charge the separate packs. They can also reset any "time bombs" in it that cause an otherwise good pack to show bad.
Maybe Santa will be good to me some year.

You might just need a new battery. Maybe the PC power management chip is going. A Dell common thing.
Leaving a laptop plugged in with a full battery is known to reduce the life. Asus for one recommends that you don't leave the charger plugged in all of the time even when shut down. And setting Windows to charge the battery to 85% instead of 100% increases life.
That's all I got.
dishstaller
That's all I got.
That was quite enough....I definitely learned something from your post. Thanks
TRG
TRG
Pub Member / Supporter
Last reply · posted in Computers and Gadgets
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
5 Replies · 288 views
b4pjoe
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
If you can't get into the router to reserve an IP address just don't use DHCP on the device that needs connected and assign it to a specific IP address in the network settings.
  • Like
Reactions: harshness
HipKat
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
They are not. Your best bet is to set up a third-party router, attached to the Starlink for your server, that you can get into, like a Linksys, etc
  • Like
Reactions: Foxbat
Foxbat
…it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
The Starlink V5 Install Kit I just got comes with the Mini Router. It is pretty limited in what it can do. For example, it can provide only one IP subnet at a time, no Guest Network, but it does support the pass-thru to a third-party Router. You can also split the Wi-Fi into separate 5 GHz & 2.4 GHz SSIDs to help some IoT devices that don't support 5 GHz bands to work.

The larger Starlink Router that still comes with the V4 Kit does support a Guest Network with separate IPv4 Subnet, but it's $120 from Starlink. And it still won't do DHCP Reservations.
harshness
If you can restrict the DHCP address space to assign addresses to one end of the subnet (i.e. x.x.x.50+), you can manually assign the IP address on pretty much any operating system. This is a default behavior on several popular routers. As the Router Mini only supports 235 devices, I expect that's already done.

Another option is to use a router that supports PoE to power the antenna. This article discusses that option (under PoE Power heading):

  • Like
Reactions: Foxbat
Foxbat
Now that I've had the v5 kit with the Mini Router, it's not as bad as I first thought. Yes, no DHCP reservations, but you can set up multiple SSIDs that have separate IPv4 subnets, and like the big brother, you can select from 192.168.x.0/24 or 10.x.0.0/16 (where "x" is 1-4).

You can also split a subnet and have different SSIDs for the 5 GHz and 2.4 GHz channels to handle some IoT devices. I haven't discovered what subnet the 2nd NIC on the router assigns, I'm guessing it's the first subnet.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in The Chit Chat Club
2 Replies · 52 views
dishstaller
Sorry for posting the wrong link. Just corrected it.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in The Chit Chat Club
Terrible tragedy. You would think that they would have safe guards in place that would prevent something like this from happening. I guess if you are going to ride in a passenger train it might be best to get a car near the rear.

2 Replies · 56 views
  • Sad
Reactions: Jimbo
Jimbo
Terrible tragedy. You would think that they would have safe guards in place that would prevent something like this from happening. I guess if you are going to ride in a passenger train it might be best to get a car near the rear.

They will have to look at the switching sections to determine WHY 2 trains were on the same track ... at the same time.
dishstaller
Thought this article might be of interest to some of you who might travel via train.