I hate to make a dupe, but I'm desperate for answers.
My CS8100 HD has decided it doesn't like a particular channel. I tried to re-scan for the DTV transition and when it went to WSFL-DT, it decided to re-boot upon the moment it scans in. I've tried outdated hackware to see if it fixes the problem and no luck. I also wiped it with the "clear software" program and then re-loaded factory software. No luck. If I can't record this channel, there's no point in having this receiver. I'm really irritated.
I called the engineer over there and told him about it and asked if anything changed in the stream and he said no. SO....not sure what is going on here.
If this is something similar to the problem with Voom receivers and CBS owned stations, I'm gonna be really upset.
This scenario is different though.
Coolsat receiver taking in a Tribune owned TV station. Does anyone have a Tribune owned station and a Coolsat 8100 HD to test?
I assume that you tried doing a manual scan of just that channel, instead of the auto-scan?
If so, what were the S/Q bars doing?
I too, had problems scanning in one channel yesterday, although my 8100 didn't reboot, it just wouldn't scan in the main channel, only the 2nd SD channel. In MY case, I noticed that the S/Q bars were jumping around wildly, compared to the channels that scanned in fine, which were nice and steady.
I'm thinking that I'm getting a lot of multipath on that channel, which happens to be a channel that is taking over it's old VHF slot, after spending the transition period on UHF, where it scanned in fine. I know that multipath is more likely on VHF, and I notice that your channel is on CH-19, which is UHF, so it's perhaps less likely in your case, but I notice that the antenna pattern for your station is highly directional, with strong signal north and south, and weaker to the east and west. So I thought that if perhaps you're west of the transmitter, you could be getting reflections off buildings or something from the strong N/S signal, which might be competing with the weaker direct signal??? Just a thought.
If it is multipath, a more directional antenna may help, at least until you get it scanned in. After the channels are scanned in, I doubt that you'll have any trouble. Another reason that this receiver really needs a channel editor.