we may have it
... is there a way to setup more than 4 dishes with diseqc switches to one receiver?
I currently have two 4x1 switches.
In our Switches Simplified FAQ, there is a design with two 4x1 diseqc switches and a very special Ecoda 22khz switch, giving you a choice of
eight LNBs.
... or setup one of my star choice dishes for 97w and 101.
Conky said:
however, iirc the starchoice dish Lnbs have switches built into them
That would be a problem, as the design above doesn't work with external switches built into LNBs.
I suppose if you had several StarChoice LNBs you could work out a combination with a 4x1 disec to cover eight birds, though.
Do they select between the two with a 22khz tone?
Conky said:
I think you can use a sw21 switch in conjunction with 2 diseqc switches
The SW21 is an old DishNetwork two-input switch, and uses unique commands.
I don't recommend them, because most FTA receivers didn't support those DishNet switches.
So, building yourself into a corner relying on such a non-standard device meant you might not be able to get a new receiver to work on your dish farm.
There is also a newer 8x1 diseqc switch, but those are probably not supported by your older receivers.
Edit! -
Wait a minute. After a re-think, I may have it!
Do StarChoice LNBFs have four outputs and switch internally with 22khz?
(I don't have any, and haven't read about 'em in way too long)
If so, use the design shown above.
Connect two of the outputs of each StarChoice, one to the ABCD and one to the EFGH group.
The rest should be obvious. :up
(does that work for you?)