[FONT="]Having owned 2 Pansat 9200hd receivers I like my Pansat 9500hdx for the following reasons:[/FONT]
[FONT="] [/FONT]
[FONT="]1 Both 9200hd units had heating problems (which I resolved but they still required fans -
methods). The 9200hd processer
always runs unless you totally remove power via the switch under the front cover door. The 9500hdx does not start the processer until you push the on/off button. The negative aspect is that it takes about 10 seconds for anything to show on the screen while it boots. The cabinet of the 9500hdx remains near room temperature on or off. [/FONT]
[FONT="] [/FONT]
[FONT="]2 The 9500hdx controls the skew, eliminating channel changing via the Motorola 922. This relieves the pain of blind scanning the vertical and horizontal separately, changing the 922 channel in between. It is great to be able to view all channels on a satellite without thinking about skew.[/FONT]
[FONT="] [/FONT]
[FONT="]3 The 9200hd units would often have no audio on the other end of a distant HDMI connection and it required unplugging and replugging the HDMI cable near the source and even then sometimes it refused to work (likely HDCP related problem). The 5v on the 9200hd HDMI output was too weak to drive the relay units for the HDMI hardware via ethernet cable (a separate 5v source was necessary). The HDMI on the 9500hdx has been flawless.[/FONT]
[FONT="] [/FONT]
[FONT="]4 The ease of usage of the 9500hdx is much improved over the 9200hd
after the period of getting used to it. It is convenient to separate the channels for each particular satellite for editing or viewing. A PC program is also available (connected via a serial cable) for uploading and downloading all data. Having the skew controlled by the 9500hdx eliminates any need to tag channels with an even or odd designation for setting the 922 channel (skew).[/FONT]
[FONT="] [/FONT]
[FONT="]5 The 9500hdx automatically adjusts its clock from channels such as PBS.[/FONT]
[FONT="] [/FONT]
[FONT="]6 The list of satellites, included separate ones for Ku and C-band for relavent satellites. [/FONT]
[FONT="] [/FONT]
[FONT="]7 The 9500hdx is easy to modify to provide 19vdc to lnbs for vertical as well as horizontal. As built, my 9500hdx supplied 13.2vdc for vertical and 18.4vdc for horizontal. The reason this is important is that many lnbs need 15vdc or more to operate (like an NJR2535S). Using the 922 to keep both the C and Ku lnbs powered up sometimes causes the receiver to confuse and accept a C-band IF while scanning for Ku, because the Diseqc switch filters DC power to the lnb, better than the received IF. [to mod the 9500hdx board simply raise the collector of Q20 from the pcb –
pic).[/FONT]
[FONT="] [/FONT]
[FONT="]7 The cost of the new 9500hdx (with wireless remote) was about the same as either of my
used Ebay 9200hd units.[/FONT]