Well, got all my cable wiring and switches stuffed in a large cable-style utility box, with new compression fittings on all the RG-6 quad shield, and new runs into the house. That's mounted on the side of the pole for the motorized ku dish (which is my wiring hub area, with 2 buried 50 foot black plastic wiring tubes running into my house crawlspace) There's a DPP44 for Dish, a Chieta 4x1 DisEqC switch, and a WNC 4x8 modded switch with 18v on the non-22k side all stuffed in there. Yes, the door closes! I also got the c-band only ortho feed installed and (I think) peaked (signal levels are good), but only got finished around 5pm and I was exhausted (and COOKED by the sun) by then, it was a HOT day. So, I took a shower and am just relaxing for now. I still have the motor controls separate, as the V-Box X is not yet run through the microHD.
I work 12 hours Saturday, and then 12 hours Sunday, so won't have time to check anything else until Monday. I have to properly wire-tie everything, and double-check if there's any peaking to be done before hooking the V-Box to the microHD, and seeing what happens when I run that via DisEqC, while my ku dish is USALS.