When doing transponder or satellite scans, what is the "Network" option for? I haven't seen it or the purpose mentioned anywhere.
Owners Manual Page 47:
Network Search – Scans the Network Information Table and logs any services that the uplinker identified.
Note: Active only when scanning pre-programmed transponders.
If the transponder does not have a Network Information Table, the feature will not log any services.
I've experienced a few receiver lock-ups and had to pull power to get it back. I've just had it freeze up again while locked on a strong HD signal (S=90, Q=75) and starting the full screen signal meter. This was very similar to one last night. Is it common to be experiencing MicroHD issues that require power rebooting?
Be sure that the microHD is running the latest firmware. There have been a few reports. Some could be related to not performing a Factory Reset after updating the firmware and others could not be replicated.
If this happens and can be replicated, please document and report the specifics like satellite, TP, channel, switch and motor settings.
Do you guys delete all the pre-loaded transponders and do detailed scans?
Not usually. If the TP list is getting old with inactive TPs, then I often will. Also when testing to determine if new firmware and LNBFs have an effect on number of TPs found.
What's the difference in "Basic" and "Detailed" scans?
Owners Manual Page 47:
Blind Scan – Normal search of the entire satellite with user defined parameters for new transponders and channel logging with normal analysis
Blind Scan – Detailed search of the entire satellite with user defined parameters for new transponders and channel logging with extended analysis.
The Detailed Scan takes longer and spends more time analyzing the signal for channels.
Are the private forums being used here to discuss these types of topics?
The private "What's Up There" Forums usually discuss specific finds that are not public knowledge, but little tech talk bout technique or tricks.