Well, I was finally able to secure a signal using the last set of instructions where I took the motor off, set dish on pole, followed all directions. Now I want to install motor , switches etc... What I find confusing is that dishpointer.com , for my lat. =33.74 , Long -112.33 gives me these settings. Motor lat at 33.74, elevation= 50.8, dish elevation at 40.0 degrees, declination at 5.5. Which elvation do I use??? dish elevation or elvation of 50.8??? Do I use true azimuth or mag. azimuth?? And do I subtract declination angle at dish elevation or where? I am really grateful for going this far with you guy's help, I want to go further. Thanks very much-JG