Hey,
I'm working with our local access station and high school to start up a newscast. Long story, but we licensed the CNN Newsource feeds and we're working to configure the receiver--a Scientific Atlanta D9223.
So--long story short--I took the receiver and a monitor outside, aimed the dish, got a signal strength of 53ish according to the D9223 (61ish according to my Pansat 2500a), and picked up the CNN Feeds.
Here's where it gets mysterious--I took the video equipment back inside, hooked it back up, got a signal level of 53 again--but this time, no matter what I seem to try, I get a "NO LOCK" and "No Signal" message on the D9223. I can pick up the unencrypted channels on AMC-3 using the Pansat, and I'm actually using the exact same cable I used when I hooked everything up outside--and yet I can't get a signal with D9223.
I've factory reset the unit a few times, quadruple-checked the connections and settings, and still no luck.
Any ideas? I'm out of 'em. Thanks in advance for any suggestions!