Social Feed

Stuart Sweet
Staff member HERE TO HELP YOU! Pub Member / Supporter Cutting Edge
· posted in The Solid Signal Blog
By now you probably know that you can get satellite TV on your yacht if you want. Of course the challenge for most of us would be getting that yacht in the first place, but that's another story. Let's say for a moment that you're doing ok in life, that you have a small cabin cruiser and you want to take it out to sea for a while. Sounds great, right?

If you're thinking about a life at sea, you may be wondering if that satellite TV purchase is worth the money. After all, satellite TV for marine applications isn't cheap, so one of the things you're probably asking yourself is whether or not you'd actually be able to get coverage while out there.

The easy answer: yes


In many cases, the answer is yes. Satellite TV is designed for land-based reception, but the beams that come down from the satellite don't just stop right at the shore. That would be pretty difficult and expensive to achieve. In fact you can get satellite TV in a lot of offshore locations that you wouldn't expect. While I am pretty sure it's not legal, I'm equally sure that folks in Havana can get Miami locals.

It really varies from point to point but it's pretty safe to say that you can usually get satellite TV service 50-100 miles off shore. Sometimes you can get much further, as for example much of the Caribbean is covered by DIRECTV and DISH.

There are coverage maps that are available for different marine dishes and carriers. Your Signal Connect representative can help you with that when you call us at 888-233-7563.

How can you get better reception out there?


The answer to getting better reception on a boat is simple: get a bigger antenna. Intellian, the leading manufacturer of satellite antennas for marine, has a complete line of dishes in different sizes. Marine satellite dishes are measured by the size of the actual part that does the reception. The outer shell, called a radome, is generally a few inches larger to accommodate the movement of the antenna inside.

Intellian's smallest antenna clocks in at a svelte 30cm, about a foot wide. For those who need to get service further and further away from shore, larger dishes are available. You'll need a 60cm (2 feet, roughly) dish to get all channels at once from US carriers, but the sizes keep going up. The largest one is an astounding 2.4 meters in diameter. That's over 7.5 feet to you and me. Of course, as the size of the antenna goes up, you'll need a larger vessel to mount it to. As much fun as it would be to see someone try to rig a 100cm dish to a dinghy, I feel like the results would be fairly tragic.

Eventually, though, you'll lose signal


If you truly do plan a trans-ocean trip, and I know most of us never will, there will come a point where you lose satellite TV service. It will probably happen about 100-150 miles off shore There just isn't any service out there and there won't be anything until you get to the other coast. At that point you'll need different satellite equipment for the most part. Of course, that's why Signal Connect can also offer satellite internet from companies like Viasat and Starlink.

For people with small cabin cruisers who just want to watch a little satellite TV, luckily though… you won't have to worry about losing reception just because you lose sight of shore.

When you're ready to talk about marine satellite products, call the experts! No one has done more marine satellite activations than Signal Connect. We know how to take care of our customers. Find out the Signal Connect difference… call 888-233-7563 during East Coast business hours. We'll take it from there!


The post How far offshore can you be and still get satellite reception? appeared first on The Solid Signal Blog.

Continue reading...
0 Replies · 220 views
dfergie
Staff member HERE TO HELP YOU!
Last reply · posted in What's Cooking?
We have a Breakfast and Dinner thread so... :)
Continuing from the Breakfast thread, found Cornbread mix so ...
Yellow Cornbread Mix
2 Hatch Green Chiles -diced
1 Egg
2/3 cup of milk
add to greased pan
Bake for 400f 20-25 minutes(From instructions)
now to put together and try... this to go with pinto beans...
5448 Replies · 336076 views
M
Garlic cheese bread
Green beans
Apples
Chocolate Milk
Some weird noodles. ;)
(They have salad and a couple other fruits if wanted)
  • Like
Reactions: dfergie
TRG
TRG
Club sandwich and corn chowder. Iced tea.
dfergie
Chili dog bowl, water… (homemade chili)
TRG
TRG
Leftover wanton soup and pork fried rice. Water.
dfergie
IMG_5955.webp

Sweet tea…
  • Like
Reactions: TRG
Scott Greczkowski
Staff member HERE TO HELP YOU! Cutting Edge
Last reply · posted in The Chit Chat Club
Sometimes a thread gets so many posts in it that is can cause issues for the server so that why today we introduce The Song Name Game Part 3!

So let the game continue!

The last song was added by Bobby who posted...

One Meat Ball - Andrews Sisters

CONTINUE ON AND HAVE FUN! WELCOME HOME TO SATELLITEGUYS.US!

Here are the original rules for the game as posted by WebbyDude back in 2006. http://www.satelliteguys.us/threads/68645-Song-Name-Game

Just name a song title and the band who performed it. The next person does the same thing, but needs to list a song title or band name which includes a word from the previous entry. Pick songs from any genre.

Example:

Long Live Rock and Roll -- Rainbow

Rainbow in the Dark -- Dio

Another example:

Ride the Lightning -- Metallica

Lightning Strikes -- Ozzy Osbourne


Get it?


An additional note: we all know that song titles, sometimes, use profane words. Because this is a family friendly website it is advised that you clean up that title up a bit. This is accomplished by using something like sh!t instead of the real word. Thanks....
68658 Replies · 2680216 views
  • Like
Reactions: c-spand
dishstaller
I Wanna Talk About Me - Toby Keith
  • Like
Reactions: RaiderPower
Bobby
98.6 - Keith
harshness
I'm Easy - Keith Carridine
  • Like
Reactions: RaiderPower
gms49ers
It's Easy - Boston
RaiderPower
Take It Easy On Me - Little River Band
  • Like
Reactions: dishstaller
R
Last reply · posted in Computers and Gadgets
Lately my eight year old Dell laptop has been shutting off even when I have a full battery. I have had to keep it plugged up all the time to keep this from happening. Any idea what is causing this? I replaced the battery about three years ago.
2 Replies · 46 views
arlo
A recalibration might be needed. Even if it shows full, the individual cells may have become unbalaced. And the BMS chip in the battery reports false information to the pc.
Try this. Start it up in the bios/uefi and leave it there until the battery dies and it shuts off.
It might just keep running longer than in Windows. Or run for a short while and shut off.
If it's the first case. Probably just needs a balancing. If the latter, the pack might just be dead.
Not throwing stones but perhaps just a cheaply constructed battery with substandard cells. Could be.

Patience. Keep restarting it in bios/uefi until it won't fire up anymore.
Then plug the charger in and let it complete a full charge. And see what happens. If it's better.
Do the same thing one more time. Run it until it dies dead-dead. Then just let it charge, pc shut off.
When charged, it might be better. It might not be.

There are bench jigs that read the actual BMS and override it to let a tech manually monitor and charge the separate packs. They can also reset any "time bombs" in it that cause an otherwise good pack to show bad.
Maybe Santa will be good to me some year.

You might just need a new battery. Maybe the PC power management chip is going. A Dell common thing.
Leaving a laptop plugged in with a full battery is known to reduce the life. Asus for one recommends that you don't leave the charger plugged in all of the time even when shut down. And setting Windows to charge the battery to 85% instead of 100% increases life.
That's all I got.
dishstaller
That's all I got.
That was quite enough....I definitely learned something from your post. Thanks
TRG
TRG
Pub Member / Supporter
Last reply · posted in Computers and Gadgets
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
5 Replies · 284 views
b4pjoe
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
If you can't get into the router to reserve an IP address just don't use DHCP on the device that needs connected and assign it to a specific IP address in the network settings.
  • Like
Reactions: harshness
HipKat
I set up a music server for my brother a few years ago. It's basically a small headless computer but it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
They are not. Your best bet is to set up a third-party router, attached to the Starlink for your server, that you can get into, like a Linksys, etc
  • Like
Reactions: Foxbat
Foxbat
…it needs to have a DHCP IP address reserved for it in the router settings. This was easy to do in his DSL router. He's switching to Starlink now and I was wondering if these setting are easily accessible in the Starlink router. I'm pretty sure he will be getting the latest V5 router.
The Starlink V5 Install Kit I just got comes with the Mini Router. It is pretty limited in what it can do. For example, it can provide only one IP subnet at a time, no Guest Network, but it does support the pass-thru to a third-party Router. You can also split the Wi-Fi into separate 5 GHz & 2.4 GHz SSIDs to help some IoT devices that don't support 5 GHz bands to work.

The larger Starlink Router that still comes with the V4 Kit does support a Guest Network with separate IPv4 Subnet, but it's $120 from Starlink. And it still won't do DHCP Reservations.
harshness
If you can restrict the DHCP address space to assign addresses to one end of the subnet (i.e. x.x.x.50+), you can manually assign the IP address on pretty much any operating system. This is a default behavior on several popular routers. As the Router Mini only supports 235 devices, I expect that's already done.

Another option is to use a router that supports PoE to power the antenna. This article discusses that option (under PoE Power heading):

  • Like
Reactions: Foxbat
Foxbat
Now that I've had the v5 kit with the Mini Router, it's not as bad as I first thought. Yes, no DHCP reservations, but you can set up multiple SSIDs that have separate IPv4 subnets, and like the big brother, you can select from 192.168.x.0/24 or 10.x.0.0/16 (where "x" is 1-4).

You can also split a subnet and have different SSIDs for the 5 GHz and 2.4 GHz channels to handle some IoT devices. I haven't discovered what subnet the 2nd NIC on the router assigns, I'm guessing it's the first subnet.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in The Chit Chat Club
2 Replies · 51 views
dishstaller
Sorry for posting the wrong link. Just corrected it.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in The Chit Chat Club
Terrible tragedy. You would think that they would have safe guards in place that would prevent something like this from happening. I guess if you are going to ride in a passenger train it might be best to get a car near the rear.

2 Replies · 55 views
  • Sad
Reactions: Jimbo
Jimbo
Terrible tragedy. You would think that they would have safe guards in place that would prevent something like this from happening. I guess if you are going to ride in a passenger train it might be best to get a car near the rear.

They will have to look at the switching sections to determine WHY 2 trains were on the same track ... at the same time.
dishstaller
Thought this article might be of interest to some of you who might travel via train.