proud of ya too
Yea, sometimes all it takes is a big hammer.
In this case, a really big soldering iron is the key.
Get it on, get it hot, flow the solder, and get off it.
Just like doing copper pipe.
For anyone contemplating following in Jim's footsteps with a little wimpy iron, forget it.
You need one with a nice big tip!
I remember building a kit many years ago, and it needed a lug soldered into the middle of the big chassis.
I pulled out my Dad's 100 watt iron with a half inch square tip, and was amazed how easily that went down!
The solder flowed like butter.
