2 dual lnb with 2 receiver with 2 4x1 DISEQC

Status
Please reply by conversation.

saifeldawla

Member
Original poster
Feb 27, 2008
7
0
I CONNECTED 2 DUAL UNIVERSAL LNBS THROUGH 2(4X1)DISEQC TO 2 PCI DIGIAL RECEIVERS(TWINHAN& SKYSTAR 2).TWINHAN WORKS FINE BUT SKYSTAR 2 ALWAYS GOT ONLY ONE SATELLITE COULD YOU PLEASE TELL ME WHAT IS GOING WRONGE
 
what have you tried?

This question might get better support over in our Free to Air PC DVB Discussion department.

I'd say maybe the one card doesn't do diseqc commands very well, but not being a card expert, I couldn't swear to it.

Maybe if you are using different software for the two cards, one doesn't have good support or properly setup for diseqc switches.

The switch could be bad.

The cable run may be longer on the failing receiver (?), or not well grounded...
 
thanks for reply I found that digiwavetechnologies in their web page show two connections with full case and smaal case diseqc . they mentioned full case for more than one receiver and small case diseqc for onr receiver,I used the both bigger one with twinhan(it has on its software 22kz)
and the smaller with skystar which there is no signto 22khz
 
Status
Please reply by conversation.

I got it to where I like it. :)

How to equip Prodelin 1.2 M dish.

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

Who Read This Thread (Total Members: 1)