I just purchased a Dish 1000.2 system with a triple LNB. I have two coax lines installed (left from my Dish 500) but I am only using one of the two as per the dish setup instructions. The single coax is connected from the LNB port 1 to the DPP separator and then from the separator to my 622 receiver thru (2) 6" pigtails. When I run the check switch test:
Port 1 says 129, ok.
Port 2 says 119, o.k.
Port 3 says "conn", "x".
In the instructions port 1 is 119, port 2 is 110 and port 3 is 129 ?
I am able to receive both the 119 and 129 signals at 96-98% but no 110 signal at all ? Any suggestions ?
Port 1 says 129, ok.
Port 2 says 119, o.k.
Port 3 says "conn", "x".
In the instructions port 1 is 119, port 2 is 110 and port 3 is 129 ?
I am able to receive both the 119 and 129 signals at 96-98% but no 110 signal at all ? Any suggestions ?