Driving a motor threw signals from a DiSEqC slave IC stm8splnb1

[flo788]

Not sure if that's the right place for such a question. If not please correct me.

I figured out that with an STM8SPLNB1 it is possible to control 4 output pins threw DiSEqC (from the datasheet: "4 output pins for control of a legacy matrix.")
Unfortunately, I can't figure out which commands you have to send and which configurations are necessary. Does anybody has some experience with the IC?
STM8SPLNB1 https://www.st.com/en/microcontrollers-microprocessors/stm8splnb1.html

Best regards. Thank You!

 

[Magic Static]

to the forum flo788 There are a few members around that can understand that level of control. Unfortunately I'm not one of them even though I like a hot soldering iron.

 

[primestar31]

Perhaps IF you explain your plans on what you want to do, or are trying to accomplish with this, we might be able to give you better answers?

 

[a33]

Welcome to the forum, flo788!

"4 output pins for control of a legacy matrix."

That sounds like normal (legacy) VL/VH/HL/HH control, I would assume?

But in the topic title you mention motor control?

Please describe in more detail what you want/what you have in mind; to enable us to answer you better! (As PS31 already wrote.)


Greetz,
A33