Looking for a 6-7 foot - will trade 10 foot

Status
Please reply by conversation.

signal.quest

SatelliteGuys Pro
Original poster
May 29, 2009
176
0
Near Scranton, PA
I don't think I have enough room for my 10' perfect 10 mesh dish. I think I can fit a 6-7 foot dish. Please reply if near northeast PA and would like to trade. I also have other computer/electronics to trade if not interested in the 10' BUD. Thanks.
 
I did not think I was going to be able to us the 6' I put in. Turns out I am now using a 10'.
Are you sure?
 
from what I read on the forum -

Used 5' and 6' BUDs are pretty rare to find in the wild, from what I've seen here on the forum.
Of course, 6' solid prime feed are readily available from WSI (top of the page) and Sadoun.
Not sure if SatelliteAV (top of the page) carries that size in his GeoSatPro line.
What I do see folks talking about a lot are 7½' and 8' BUDs (the rare Birdview is 8½').
So, if you think 8' might fit, keep on the lookout for such a dish. ;)
 
I'm here in Iowa, don't know if that would be to far, or meet half way. Been looking for larger mesh BUD. I have a 6ft SAMI. Interested??
Half way is about an 8hr drive to Richmond, Ind.
 
Last edited:
Thanks for the offer. I think that would be too much time to drive. I would buy a new one rather than drive that far. I am trying to save money. Thanks.
 
Status
Please reply by conversation.
***

Users Who Are Viewing This Thread (Total: 1, Members: 0, Guests: 1)

Who Read This Thread (Total Members: 1)

Latest posts