I have a 1002 dish with the Dish Hopper & single Joey setup. I recently lost tuner 3 during my check switch test. I borrowed another neighbors lmb and his worked fine when (check switch) but when I reinstall my existing lmb and retest then once again I loose tuner 3? Its strange to me as I still have tuner #1&2 just not #3.
My Setup
3 head lmb with F connector #1 connected to>hybrid solo hub ODU port.
Hopper/Sling > connected to > solo hub Host port.
Joey >connected to Client port on hybrid solo hub.
I have a few questions if I may,
1) How does the hybrid lmb supply signal for tuner #3?
2) Is there a way to fully test an lmb with a meter like a Birdog signal meter? Since mine seems to only be partially impaired?
3) How do I know which specific lmb i can use to replace my bad one? I believe I have a Dish Pro Hybrid lmb? There are a few out there that look almost identical?
I am good at breaking down and resetting up the system but when things like this happen it is unknown to me? Any assistance would be greatly appreciated.
God Bless America
My Setup
3 head lmb with F connector #1 connected to>hybrid solo hub ODU port.
Hopper/Sling > connected to > solo hub Host port.
Joey >connected to Client port on hybrid solo hub.
I have a few questions if I may,
1) How does the hybrid lmb supply signal for tuner #3?
2) Is there a way to fully test an lmb with a meter like a Birdog signal meter? Since mine seems to only be partially impaired?
3) How do I know which specific lmb i can use to replace my bad one? I believe I have a Dish Pro Hybrid lmb? There are a few out there that look almost identical?
I am good at breaking down and resetting up the system but when things like this happen it is unknown to me? Any assistance would be greatly appreciated.
God Bless America
