New install HR20-700 and 5LNB dish

Status
Please reply by conversation.

bigdanjr

Member
Original poster
Oct 30, 2006
6
0
I just had the new hr20-700 and 5LNB dish installed on Saturday 10/28/2006 in Monmouth County,NJ. The installer did a good job, removed my old dish installed the new dish. I also had him use the the Zinwell WB68 multiswitch I bought on ebay. It was very cloudy on Saturday in NJ. Most of my signals are great. The 101 are almost all between 92 - 96 on average. But a couple of the transponders on the other stats are 0.
I seem to be getting all the channels. But after reading the other posts I am wondering if I should call them back to fine tune the other stats.
He also coupled the two exisiting wires from my old dual lnb 18" dish. I just wrapped the connection in electrical tape so it wouldn't get wet.
Thanks in advance for any advice.
 
Register to hide this ad
Normally the installer supplies the WB68. You might get credit with D* if you tell them you bought your own.

Some of the transponders are spot beamed to areas other than yours, so it is normal for some to be 0 or very low.
 
paulman182,
Thanks for the information. Since I am having no problems getting the channels, I will leave well enough alone. I have the D* insurance coverage and I believe they will realign the dish for free if there is a problem.
 
Status
Please reply by conversation.

NFL Week 8 SundayTicket/SuperfaN Sched

HD Fine Tuning