His approach was to tie a line directly into the 119 LNB and bypass the switch but the problem with getting only even or odd on a checkswitch remained. He then tried it with a 311 he brought with him and the issue was duplicated. So he decided to take off the existing 119 lnb and put on a legacy one and did a checkswitch to (re-program the reciever) as he put it. I will say that after the checkswitch with this older LNB all the channels were coming in fine but this setup could not remain as the legacy LNB is not compatible with the DP44. So the next step was to install a new Dish Pro LNB from his van and upon doing this the 119 channel problems have vanished. So he hooked it back up through the switch and then ran a checkswitch on the 508, this time all was green and flagged as "ALL" instead of "X" or ODD/EVEN..