Re: [VOOM/DISH/OTA] Re: Voom and DVR 942

  • Thread starter Sean Butler
  • Start date
  • Replies 0
  • Views 1K
  • WELCOME TO THE NEW SERVER!

    If you are seeing this you are on our new server WELCOME HOME!

    While the new server is online Scott is still working on the backend including the cachine. But the site is usable while the work is being completes!

    Thank you for your patience and again WELCOME HOME!

    CLICK THE X IN THE TOP RIGHT CORNER OF THE BOX TO DISMISS THIS MESSAGE
S

Sean Butler

Guest
Original poster
> I have the Sensar III. My TV has an ATSC tuner so I took the voom box
> out of line and now get now signal, so I definitely need the amp. I'm
> going to buy one of these:
>
> http://www.summitsource.com/prods/AMW937.html



Just to follow up, I bought one of these and it works fine. Took some
coax re-adjustments and a diplexer, but the Dish installer was able to
figure it all out. I was skeptical of his plan, but in the end it
works fine.

I pretty much get the same level of reception as when the voom stb was
powering the antenna -- I was hoping for a little bit better. Oh well.

Overall the 942 is a pretty nice set up, though I'm still learning it.
I've recorded several HD movies and it works like a charm and PQ is
good. Not quite as intuitive as tivo, but not terrible. There are a
ton of options for everything from HDTV set up, to TV1 and TV2 setup,
to the DVR options, etc. It will take a while to learn fully.

So far I'm happy with Dish and Voom10. I run TV2 on the 942 to the
rest of the house, still experimenting with dual vs. single mode.
Single gives PIP with 2 HD channels which is pretty cool. :)

The product sheet on dish's web page barely scratches the surface:

http://www.dishnetwork.com/downloads/pdf/product_brochures/942_Prod_SheetWeb.pdf

/Sean




------------------------
 

Similar threads

B
Replies
0
Views
2K
bluebird93@aol.com
B
B
Replies
1
Views
2K
Bruce Grodner
B
R
Replies
0
Views
2K
Robbie Brooks
R
T
Replies
0
Views
2K
Thomas Barthel
T

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

Who Read This Thread (Total Members: 1)