Titanium Satellite ASC1 DiSEqC 1.2 Positoner - Firmware Update 20140930v1

Status
Please reply by conversation.

Titanium

AI6US
Original poster
Lifetime Supporter
May 23, 2013
7,645
9,050
Meadow Vista, Northern California
New and Improved ASC1 firmware is now available for download - 20140903v1 at: http://titaniumsatellite.com/updates

Important Notice: This firmware can only be loaded with ASC1 Loader/Editor version 1.8. Once this firmware is loaded, only Loader/Editor version 1.8 and higher will read and write Satellite Lists.
  • Modify - Continuous Move Mode Voltage: The M1/M2 motor voltage is now fixed in the continuous motor move mode. Motor Ramp In/Out is eliminated to address compatibility issues with AJAK HH motors and custom high count sensors circuits.
  • Modify - Relay Reset: The Reed sensor may land in either an open or closed (high/low) position at the end of a motor move. The Reed sensor may start in either an open or closed (high/low) position at the beginning of a motor move. This may result in a sensor count being added or dropped depending on the Reed switch position setting. The sensor relay is cleared to prevent over/under single count errors.
  • Add - Count Sampling: Sensor pulses sampled 10x

Thank you for your continued support of the ASC1 and for your feedback to make it even better!
 
Status
Please reply by conversation.
***

Users Who Are Viewing This Thread (Total: 1, Members: 0, Guests: 1)

Who Read This Thread (Total Members: 1)