Two Hopper 3 DVRs Installation

[charlesrshell]

Now that my Owned H3 fried itself. What gear can I remove for just one H3? Already took down the 129 Wing Dish.

Did you get a replacement for your fried H3? You can leave gear in place in case your other H3 bites the dust.

 

[Bobby]

Now that my Owned H3 fried itself. What gear can I remove for just one H3? Already took down the 129 Wing Dish.

You do know that DISH will replace your owned, fried, Hopper don't you. It's free....

 

[SandFarmer]

You do know that DISH will replace your owned, fried, Hopper don't you. It's free....

Yup. Been there done that many times over the past 29 years. Since not having it, I have found better and cheaper ways to get what little programming in need from it.

Just wondering how far down I can strip down all the gear on my chimney.

The 129 J-Arm grew an Outdoor Long Range AP. I already have several unused RJ lines that are going to be IPoE from the rack. Just wondering how much gear I'm going to be able to put up there.

Sent from my S61Pro using Tapatalk

 

[DialgaChampion]

Twa Coaxes from the LNB if it's Eastern Arc (2 "Eyes") and three if it's Western Arc and yes, the power inserter, it's required

Yep just swap the lnb with a dpp lnb and connect the 42 switch.

Finally got around to trying to set everything up. Need some help because I've got an issue.

1st Hopper 3 works fine.

2nd Hopper 3 doesn't show any channels in my Top 200 package in the guide, even though it's set to All Subscribed. But it does see the 1st Hopper 3 and can access the recordings on it.

Here's my setup:

• DPP EA 61.5/72 LNB on the dish. 2 Coaxes going from LNB into the DPH42 switch.
• DPH42 "Receiver 1" port > Power Inserter "To Switch" port..... Power Inserter "To Receiver" port > Duo Hub "ODU 1" port.
• DPH42 "Receiver 2" port > Duo Hub "ODU 2" port.
• 2 Coaxes from both Host ports on the Duo Hub into both Hopper 3s.

I've spent the last few hours troubleshooting, no success. I did the Test Installation on the Diagnostics screen. Red button. Held Power Button for 15 seconds.

Also tried several different configurations with the coax cables according to Google's AI suggestions. Tried connecting both a Solo Hub and a Duo Hub (I don't have 2 solo hubs at the moment), having each Hopper connected to each hub independently. Tried connecting Receiver 2 from the DPH42 directly into the 2nd Hopper 3. Tried having the Power Inserter connected both before and after the hub.

I even checked my account online. Both Hopper 3s are authorized and "Powered" on the account. Even tried "Wake Up Receivers". That second H3 still won't show my channels in the guide at all.

According to Google's AI, it thinks this is the problem:

• - When you plug two Hopper 3 units into a single Duo Hub, the hub cannot allocate the correct satellite transponder frequencies to both boxes simultaneously.
• - As a result, the first Hopper 3 hogs the satellite line, while the second Hopper 3 gets locked out of the satellite signal entirely—causing an empty guide and blocking live TV. The unlinked status on the whole-home screen occurs because the software recognizes the conflict and stops integration.

But none of its solutions have worked. Any ideas?