Sorry I don't remember which one I chose but just try one at a time and you will find it.
You can read your code from your remote and post it for the OP following these steps.
Press and hold the clear/white mode button on the remote labeled "TV" for a few seconds. The lights will all turn solid at the top - Let go. The TV Button will flash.
Press the # button twice
The TV light will now begin flashing. count the successive flashes until it pauses momentarily this is the first number (note that a very short flash indicates a 0)
continue to count the next set of flashes for the second number
do the same for the third
If your remote is in limited mode, it will also flash a 1 for a 4th number. You can ignore that number unless the OP wants to put his remote in limited mode.
These steps can be very useful if you ever need to replace your dish network as you don't have to power scan for all your devices again.