Recent content by WyrTwister

Are you trying for Spanish language channels ? God bless Wyr

Some of the older Pansats would do skew on a CoRotor and operate a 22 khz switch . Do not know if yours will ? God bless Wyr

You HAVE to have The whole dish / motor assembly pointed due geographic south ( not magnetic south ) when the receiver commands the dish to reference point ( due south ) . If you do not have this right , then you will always have problems on some sats , often at the extreme ends of the...

43 degrees is pretty close to 45 degrees , which you can probably approximate by eyeball . Once you get a signal , you can tweak the skew . If you do not get it on one LNB , power down the receiver , switch to the other LNB , power up the receiver & try again . Or just blind...

A year or two ago & tried a C band feed horn & LNB on a 36" Ku band dish . Analog , a couple channels pretty strong , the rest went down in strength . I scrounged a 10' Dish and played with it for a while . I no longer use it , back to Ku . Wyr

I tried to read this , but with out punctuation , I gave up . :-( Wyr

This is a digital receiver ? Are you shooting for C band ? Ku band ? You can find a user manual at http://www.upfrontfotos.com/downloads/dsr4402x.pdf If you do not have one . Here is the chart for AMC 1 AMC 1 at...

You are going to need to use the GI receiver as master ( move the dish & control polarity ) and the DVB receiver as a slave . Since you have C & Ku band on the big dish , get two splitter , each has one port that passes DC ( the GI receiver ) , the other port does not pass DC ( the DVB...

Ku - AMC 4 channels , or maybe it was T5 . C band on a 90 CM dish , the 2 religious analog channels on G4 wyr

I am presently on 3 mb DSL . What speed is standard with the UVerse package ? Thanks

I think the newer versions of MyTheatre will do USALS ? Blind scan on a SkyStar 2 card ? Wyr

I have a HH100 & have uses it for a few years . Works fine . Wyr

So , AMC 6 is your true south ? If so , enter all the info in the receiver menues & then have the receiver tell the motor to go to AMC 6 . Be sure the scale on the motor - to - pole bracket is set for your latitude . Now , go out & tweek the dish for AMC 6 . Now ...

As several people have mentioned , it may be a conectivity problem or an IE problem . Go into Programs -> Accessaries Look for command prompt & click it You will get a DOS window on the screen type in : Ping http://www.satelliteguys.us ( or any other web...

Try a Diesque switch or a 22 khz switch ( if your receiver supports it ) to get both polarities ? Wyr