I finally got my 10' BUD up and running. I am using an Amiko Nano HD with a Vbox 6. The Vbox is in the tool shed (15ft from dish) and the FTA is in the living room (80ft from tool shed). When the FTA is right next to the Vbox the dish moves without any problems. When the FTA is inside the dish...
I'm putting up a 10' motorized Prodelin dish Tuesday. I'm looking to upgrade to an MPEG4 HD FTA. I'm planning on getting a C/KU LNB later on. Any recommendations on a receiver around the $250 range?
I'm helping a buddy install at a lake cottage, he has a directv world dish and an sl5 SWM. What kind of switch will he need to get and how will this be wired?
I got around a 60% signal on 83W using an old 74cm Primestar dish, I was unable to get a clear picture. I'm wanting the retro tv channel. I figured that dish must not have enough gain so I tried aiming my old 1.2m Hughes dish at 83W and did a blind scan. I'm getting signal but nothing comes up...
I got this dish from a buddy who recently bought an old gas station. I don't really know anything about it. I'm just wondering what kind of modem does it take to run this and what it was used for?
I tried connecting a JGS motor which has 5 wires to my V-Box 6 with no luck, the wire colors are red, white, green, orange, and brown. I know that the white and red are for power. Which two should go into the sensor ports on the V-Box?
I just got a 10' Unimesh dish from an auction, when it was removed they cut the pole at ground level instead of digging it up. I got 24 extra inches welded on at work which makes the pole 6'. Is 2' in the ground with 60lbs of concrete enough?
I recently acquired a 10' Orbitron. I'm not sure what kind of motor is had but I'm using a Vbox 6 and a Coolsat 7000. I would like to pick up 91 - 135. For some reason I can only get it to hit 2 satellites with the motor. Should the Vbox be on a certain # for a certain satellite when I aim it...