Search results for query: *

I want to purchase a meter and am curious if there's one that will measure signal strength of satellite dish antenna and aerial antenna. Which one have you had best results with? Thank you. I wasn't sure where to post this question

Will 722VIP work with tailgater antenna? If not, what dual tuner dvr tuner will work? Thanks

Which port do I attach my incoming coax to? Is it possible that the built in switch can go bad? What type of symptoms would it exhibit?

Which

So do I have a 1000.4? Also, the pic I sent that showed which satellite corresponded with the coax outlet was incorrect?

How do I determine if this LNB will work on 1000.4 dish? Also, I found this wiring diagram for the western arc. Is this correct?

I'm beginning to lean in that direction. I'll do a swap to see of fixes the problem. Thanks for your reply

I do have an older receiver that I could try.

Complete signal loss, shows no signal strength on installation screen

Tv1 says complete signal loss. I look at the installation screen, no signal strength for Tv1 output. Tv2 shows 60s-70s.

1000.2 wa with 722. Tv1 shows no signal but tv2 works. Cables & connections are good. Tv1 was previously working and gradually lost 119 then nothing. Occasionally after a hard reset, Tv1 will work and tv2 has no signal. Im lost. Any ideas?

Yes I've checked that. Even ran a new coax to make sure that wasn't the problem. This dish & lnb was near a fire a couple of years ago. Could the heat from that have damaged something and it's just now showing up?

My 722 reciever shows signal strength on TV2 in mid 60s. On TV1 it's much lower. Recently, TV2 will give complete signal loss message and TV1 has audio&video. I unplug to reset. Sometimes it works, mostly it doesn't. How can the signal strength be so different? Why if TV2 is higher it gives...

Is it called a triplexer?

I have a dish network 722 receiver. I am confused as to why I get such a huge difference in the signal strength on tuner 1 and tuner 2. Can you explain?

Which port do I connect to on the back of receiver since theres a place for sat 1 and sat 2?

Do I connect 1 cable to port 1 on LNB and put a separator at the end to connect to receiver? And completely remove switch?

I am conflicted about settings for AZ, EL, and SKEW. I have found settings for 119, 110 and different ones for the combination of 119 & 110. I'm in 424 zip code area. What settings should I use?

He's pics of eyes, LNB ID tag, and dish mount. Hope this helps.

Do these pics help? LNB has 3 eyes. Can you direct me to start from scratch?

I have looked on you tube for videos but most are in foreign languages.

010qq1lql OP TV 2 is connected to home distribution out with coax. TV 1 is connected with HDMI. If I remove switch, can I connect coax ends with an end to end connector? Or should I run new unspliced coax into house? Can I run a single cable in an use a signal splitter or diplexer? I'm not sure...