Yes, nothing has changed in the setup of the Classic NA.
I simply ran a new coax first to the Twinhan then to the Classic NA.
The NA would not see any signal at all unless I had TSReader, Twinhan DTV or My Theater open. Then, it would only see the same polarity.
So, right now, I have the Twinhan out of the loop. If I turn the rear power switch off on the NA, my Ultra will not see any signal. If I leave the rear power switch on, and put the NA in standby, the Ultra sees signal and controls the dish.
I'm thinking that without using ANY applications at all that address the Twinhan it is like turning that rear switch OFF. The computer is powered on, but, there is nothing at all using the Twinhan.
It is either that, or something is defective in my card that is preventing the loop out from working correctly. I was really hoping I could put it first in the loop because all of the other wiring is already in place for the other two.
But at any rate, I will be installing my T90 in about 6 weeks, maybe sooner. In 24 days, we leave on a two week vacation, so that my interfere with putting the T90 up, nice reason to put it off though! For the T90 setup, each receiver and the Twinhan will have it's own cable from seperate DiSEqC switches that will be fed from my 4x4's so the loop out will no longer be in the equation.