Social Feed

esteveW
Last reply · posted in C-BAND Satellite Discussion
Not as easy as I had hoped.

I have my BUD hooked up to the receiver and with elevation set I'm getting only a ghost of a picture on a couple sat.s/channels. Signal is 90 but quality is 1 or 2 at best.

I set the elevation to 90 deg. - 47 lat. = 43. now I need to adjust the declination down a few degrees from the previous setting.

My mount is almost exactly like the attached drawing. I can't adjust from the bottom pivot bolt since it is already screwed in all the way. It appears that all previous adjustments were made with the top pivot bolt. There is a close up of the top bolt and it is threaded into the "long" nut welded to the dish center ring. (same with the bottom) To do any adjustment I would have to remove the pivot bolt from the eye end and rotate it out to lower the dish or in to raise it. That wouldn't be to big a deal if I had some help, but I'm doing this all by myself.

I may have to build some kind of support for the dish to keep it from tilting forward or rolling right or left. Since this adjustment will be some 'trial and error' until I get the correct angle reading, this could be tedious, at best.

Same thing if I search out volunteer help.

Maybe I mark my elevation setting and then back it off until the dish is vertical (90 deg.), block it up and remove/adjust the pivot bolt to the actual declination number. The return the dish to the proper elevation angle.

Sorry, just thinking "out loud"!

Any ideas.

Steve
10 Replies · 4346 views
esteveW
The feed horn is reinstalled exactly where it was at the old location. I'm trusting that was correct or at least close enough to give me a point to start from for fine adjustments.

The analog receiver does a skew adjustment automatically when I set up each satellite location then does the fine tuning of the E/W along with a channel scan.

Should I do a physical adjustment to the skew?? Perhaps the 'tweaking' that is done automatically lacks the range.

Something else that I'm unsure of is the physical alignment of the scaler ring/feed horn with the focal point of the dish. My BUD has the feed horn mounted on a "Button hook" and the button hook itself precludes any direct alignment method. I'm still puzzling over this problem/question. This is the reason I have place a lot of faith on the original installation locations.

I'm looking at the Feed Horn alighment template and instructions and begining to see how this adjustment is made. While I'm at it, I can verify the f/D and maybe figure out a method to verify/tweak the Focal point.

I may have to rethink all of this. I appreciate all the comments and suggestions.

Steve
phlatwound
Can you measure from the edge of your dish to the edge of your scalar at 3-4 approximately equally spaced spots? This should give you a pretty good idea if your feed is centered in that direction.

If not, you might have to try to push it manually and pull it with guy wires or consider fabricating some feed support arms to carry the feed?

Also, I think you need to be aimed fairly close on an active analog transponder for that autotune/autoskew routine to work on your 1820. I believe you can override the autotune routine in your menus and tweak it manually.
esteveW
Skew and FeedHorn adj.!

I plan to do the f/D measurements today and while I'm at it I will measure from the rim of the dish. However, even if these measurement position the feed horn in the center of the dish, there is no assurance that the feedhorn face or scalar is aimed dead center on the dish.

I'm trying to figure a way to make a 'tee square' device that I can clamp to the scalar ring to, then offset the tee square about an inch to clear the button hook tube.

Thanks for the response. Sometimes I find the answers to my question and that is often a result of just sitting down here and putting thoughts into words. The suggestions contribute considerabily to this process.

Steve
B.J.
I plan to do the f/D measurements today and while I'm at it I will measure from the rim of the dish. However, even if these measurement position the feed horn in the center of the dish, there is no assurance that the feedhorn face or scalar is aimed dead center on the dish.
.....

I wouldn't worry about whether the feedhorn is aimed dead center. That has a minimal effect on reception. I've tilted my feedhorn so that it aimed about half way to the edge of the dish, and it didn't affect reception that much, and actually in that specific case it actually improved reception, but that's another story.
Anyway the important thing is that the feed is at the focal length, and if it "looks" like it's aiming at the center, I wouldn't worry about it being perfect, because regardless of the feed's look angle, it's still receiving the same sat, because it's the dish that's responsible for aiming at the sat. Tilting the feed just slightly changes the illumination of the dish, ie which part of the dish most of the signal's coming from.
Foxbat
Supporting Founder Pub Member / Supporter Lifetime Supporter
Last reply · posted in Internet Television (IPTV) Discussion Forum
Apple has finally released their Apple TV 4K with built-in Siri and a microphone so it can respond to your queries even if you don't have the remote. It also increases in price, to $299. I had been planning on updating my current Apple TV 4K streamers, but that's $600 for the two of them, and that's a pass at this point.

At $299, it had better come with 256 GB of Storage, Gigabit (or better) Ethernet, the latest HDMI tech and standards, and one year of free Apple One. But it probably won't…
17 Replies · 238 views
Ronnie-
Meh. The 4Ks I have will do everything that these do that I need them to do.


Which that's most tech these days for anything released the last four to five years.


It's honestly a testament to how good the previous gen Apple TVs were and are.
navychop
It's honestly a testament to how good the previous gen Apple TVs were and are.

Don't tell them that. They'll adopt planned obsolescence.
navychop
Outside of gaming, would Joe Sixpack notice any difference?
KAB
KAB
Outside of gaming, would Joe Sixpack notice any difference?
Not a bit. IMO, Apple's are slow to boot up. Time is about the same with 1st gen and 3rd. Roku runs rings around them in that department. I only reason I stuck, is the Apple infrastructure, which has it's definite advantages. But $300 is a deal breaker. Later, Apple!
S
Don't tell them that. They'll adopt planned obsolescence.
they all do that anyways.. ever notice your cell phone slows down when you come up for an upgrade.. :what. apple's been making money off of software and not hardware for a while
ncted
ever notice your cell phone slows down when you come up for an upgrade
No. Makes me wonder if that is Apple or the carrier. I am on pre-paid, so I never get "an upgrade." I still have my old iPhone 11 Pro as a second line, and it runs iOS 27 just fine. My iPhone Air, which is still a current model, doesn't really seem that much faster in regular use. It is better in other ways, and worse in some ways than the 11 Pro (size), but performance really isn't a big differentiator, especially since I replaced the battery in the 11 Pro. If I had gotten enough storage when I originally bought the 11 Pro, it could still be my primary device with no issues.
ncted
Not a bit. IMO, Apple's are slow to boot up. Time is about the same with 1st gen and 3rd. Roku runs rings around them in that department. I only reason I stuck, is the Apple infrastructure, which has it's definite advantages. But $300 is a deal breaker. Later, Apple!
Yeah, they boot up a bit slower than Roku, but the OS does a lot more, so it makes sense. How often are you booting them up that is a differentiator? Aside from OS updates, mine are on all the time. I will say the ATV4K is generally quicker than the Roku Ultras I have, when it comes to launching apps and responsiveness, not that the Roku is sluggish.
  • Like
Reactions: navychop
navychop
apple's been making money off of software and not hardware for a while

What software? For iPhones? I tried to buy some image s/w IN THE APPLE STORE! They had none, and could not offer ANY s/w for iPhones
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 3 views
TWiT Tech Podcast Network
· posted in TWiT Tech Podcast Network
0 Replies · 3 views
osu1991
Pub Member / Supporter
Last reply · posted in TV Shows
2 Replies · 58 views
  • Like
Reactions: Howard Simmons
Howard Simmons

Another Tulsa King spin off.🙄
dishstaller
Another Tulsa King spin off.🙄
But.....if you like Tulsa King....looks like you would probably like this as well. I don't mind spin-offs as long as they don't involve a sassy niece who moves from the big city :rolleyes:
T
Last reply · posted in DISH Network Support Forum
I thought I would come here and find lots of complaints about the update to the dish anywhere mobile app, but am not seeing any. It used to look just like the desktop webpage. Now you can no longer filter by sports channels or movie channels. Plus that they made it look like a big button telephone and you see fewer channels in the screen which requires more scrolling. Yes I realize you can look at sports then select which sport you want to look at, I just liked being able to see all sporting events in the guide with all other channels being filtered out. Am I alone in the wilderness on this?
3 Replies · 61 views
  • Like
Reactions: dishstaller
Juan
Not alot of dish customers any more
Foxbat
I'm not a big fan of the new layout, especially on my Apple TV. It used to look like the old Guide layout on the Hopper 3, but they changed parts of that, too.
  • Like
Reactions: charlesrshell
dishstaller
I really dislike change for the sake of change
TheRatPatrol
Last reply · posted in TV Shows
Anyone else watch this show? Any guesses as to what was in the box Gibbs gave to Abby that was on her desk? It look liked it was glowing.

I also heard that someone was leaving the show at the end of this season. Any guesses as to who thats going to be?
2132 Replies · 214687 views
Jimbo

Howard ...
You don't like Tony, or Tony as the Director (he's only been there for 30 seconds now) or you don't like NCIS ?
  • Like
Reactions: Howard Simmons
Howard Simmons
Howard ...
You don't like Tony, or Tony as the Director (he's only been there for 30 seconds now) or you don't like NCIS ?
Tony as the director.🙄
Jimbo
Tony as the director.🙄
Would you rather have LaRoche ???
  • Like
Reactions: Howard Simmons
dfergie
I liked this episode and a toned down Tony...
  • Like
Reactions: Jimbo
Howard Simmons
Would you rather have LaRoche ???
No. Bring in someone new.🤔 Tony is not serious enough for me. Parker is too close to the team and Tim is too young to take over IMO.
Jimbo
No. Bring in someone new.🤔 Tony is not serious enough for me. Parker is too close to the team and Tim is too young to take over IMO.
I don't think Tim and Tony are that far apart in Age ...

Remember what Tony said to Tim when they first got back together ...
Tony said: I am the New Tony, Tim .... (something to that effect)

Tony has changed, he's been running his Security Business ... I'm sure he has grown up.

Give it time ... your judging the New Tony from the old Tony.

It sounds like Tim won't be around the Team much longer either.
dishstaller
Pub Member / Supporter Lifetime Supporter
Last reply · posted in Movie Talk
Might be worth a watch when it comes out. Looks like typical big corp against the little guy movie BUT....there is a reason this plot type is so oft repeated, it draws audiences.


View: https://www.youtube.com/watch?v=_-f9OGsKHd4
1 Replies · 14 views
dishstaller
BTW, I noticed right after I posted this that someone else had already mentioned it....sorry for the duplicate thread. Still looking forward to seeing the movie.
meStevo
Lifetime Supporter
Last reply · posted in Movie Talk
If you're going try to read / listen to the book (can't recommend the audio book enough) before this comes out, I'd avoid trailers.

Trailer below, spoiling it to make sure you read the above bold message first. The book / audio book are fantastic. Go into this blind if you can IMO!




Kind of disappointed at how much they show. A lot still to see, but man, some good reveals in the book that are just served up here.
21 Replies · 717 views
  • Like
Reactions: dfergie
meStevo
I've seen it twice. Can't recommend the audio book enough, Ray Porter's performance is amazing and there's so much more in the book than the movie.
  • Like
Reactions: Foxbat
Foxbat
"Project Hail Mary" should be on Prime Video starting Friday, July 3.
  • Like
Reactions: Howard Simmons
K
Forgot to comment. I did watch when it first came out on MGM. I enjoyed it a lot. I think reading the book made it easier to watch. Several friends commented it was a little hard to follow.
TRG
TRG
"astrophage". I read the book but didn't see the film yet.
  • Like
Reactions: Foxbat
Howard Simmons
"Project Hail Mary" should be on Prime Video starting Friday, July 3.
That's what I will be watching this weekend.🤗
  • Like
Reactions: Foxbat
K
Kindle book on sale for $2.99 today at Amazon.
dishstaller
.........there's so much more in the book than the movie.
I agree. That can go for pretty much any book vs movie. Back when I was single I would read any Stephen King or John Grisham book I could get my hands on. When you read a book you make up the scenes and characters in your mind.....the movie version always disappoints.