Very clever:
The following is just my opinion from examining a few very small pictures.
Mike's had similar designs on his site, using the
6' Prodeln, and other dishes like a
Primestar 84e.
In the past, LNBs were mounted onto that big sweeping "square-U" shaped arm.
As long as it followed the correct path, all was well.
This latest creation seems to improve greatly on old ideas. -

The big "U" is no longer a critical part of the LNB path. It's just a general mounting guide.
That short, somewhat "V" shaped sub-bracket, flies above the "U", and takes the LNB holders.
Now, you have a smaller, simpler, mounting arm, which is easier to rebuild if you need to optimize it.
Also, note the screw adjustments at each end of the "V" bar.
That gives both stability and fine tuning ability to the entire LNB support line.
It also lets you locate the dish east/west across the country, or aim it far from your TS bird, and not have to fabricate so many custom pieces.
The angle or curve of the (not really) V-shaped piece can be tweaked for north/south dish locations, to optimize LNB placement.
One thought I had, that may or may not be implimented, is that the "V" may be rolled about its axis to optimize LNB locations when the dish is used far north or far south.
Otherwise, just that one "V" structure needs to be custom-built for a given site.
Something not supported by the pictures, the flying V
could be put an inch closer to the dish than the bottom of the U.
This would allow the line of LNBs to cross from
above to below the central mount point.
For a guy who wants to make this work anywhere, it's a brilliant collection of new and old ideas! -

A home builder, who just needs to get his one dish working, might want to simplify to a custom one-of.
However, following Mike's plan would sure get ya there in style! -
Kudos, Mike!