Hey BJ, what I meant was I can now receive from the Azbox again with the editor. I realize that corrupt lists are causing the problems. Now trying to keep them from corrupting again seems almost impossible. I received from the Azbox but, when I edited it and tried to send it back, the editor screen would sit there and bring up the phrases........... antenna list. dat. dvbs, all channel,(you know like it was sending those things to the box) then goes blank a second then, just flashes conecting forever til I shut down the editor. No changes were then made to the Azbox.
I went through with the remote and I have all the sats like I want them but, I know if I ever reboot the box it will most likely lose almost all the satellites. That's happened to me so many times now.
Here's the funny thing. Even though in the Azbox the sats seem to display correctly if I now send it to the editor, a few are really strange looking. I can't even explain it so I've taken a screenshot.
Is your screenshot after you have tried editing or right after you pull them from the Azbox? It does look like they're messed up. What do those sats with the gibberish names look like on the Azbox?
I have found that if I have a configuration that is good on the Azbox, if I pull it back from the Azbox, then SAVE the 3 files before doing any editing, that I can restore the Azbox to that good configuration at a later time with no problems. However once the .dat files get at all corrupted, it's hard to get back to a clean file. I now have about a dozen different configurations saved, just from upgrading to 3877, and about the same from 2371.
When I pull data back from the Azbox, I don't try to do too much editing. I have done:
adding and deleting transponders
editing the names of satellites ,
and I *THINK* deleting channels,
however I DON'T try to:
delete satellites
or
add channels
or
edit the parameters of transponders
Those things I do via the remote.
I really think that at some point, you have tried doing some things with the editor that the editor isn't yet capable of doing.
Slightly off topic, I have noticed that even though I have assigned LO parameters for ALL of the sats I have in my list, these do NOT show up in the editor. Because of this, I have been hesitant to try editing the sat parameters in the editor, because it doesn't seem like the editor completely understands the data format. The editor DOES seem to work very well for transferring the data to and from the Azbox though, and for the items I mentioned, for which it seems to be very handy.
Anyway, if there is a likelihood that you have anything corrupted in the data, I really think the best advise is to revert to an earlier working version of the data files.