Which Galaxy satellite are you aiming for? And are you sure that lnbf is a standard lnbf, or could it be a universal type? Should be stated on a sticker on it someplace, with a LO freq listed. If you have that correct and still can't find a signal, I'd go back to the aiming of the dish. Check the firmware of the Viewsat, and whether or not the memory might be full-does it have a lot of channels on it? Do a 'factory default' or reset to clear its memory out, and then pick your satellite, set up the lnbf for that satellite, and try a blind scan. If your meter is working, and you are really on a satellite, it should store some channels, provided your receiver is ok and the cable, connectors are good.