Ok, so yesterday I finally decided it was time to switch out the LNBF on my 10' dish with a new C1PLL I've had since the winter.
I bought two of them before it was ever announced that they would one day have a C2PLL.
Since I have the intention of having two C band dishes aimed at SES-1 and SES-2 and that each would stay parked there and that each one would be dedicated to just one network per dish, I wasn't too worried about limitations of having single polarity dishes.
I had a difficult time with the new LNBF because the skew markings on it are not the same as the one I took out. I do not know which one is proper though.
After a lot of contemplation I decided that I would ignore the markings and put the new LNBF back in place in the same orientation as the old one.
I used a 3x4 switch (or is it a splitter?) to be able to feed two wires from one LNBF. This will work just fine until I buy a few of the new C2PLL LNBFs.
I tipped the dish waaaaaay over and got on a ladder and it wasn't all that bad, except for the miserable heat.
While I was out there, I bolted an old chain to the dish so that it's impossible for it to have an accidental tip over. I had several of those a few years back.
And if there is a hurricane coming I can pull it tight so the dish will be locked in place.
So I tried to find the Luken stuff on 87 but I had no luck.
I suspect my dish is not at all properly aligned. Once I get my new meter I'll see what I can do about it.
So I swung it back to SES-1 and decided to leave this dish dedicated to MeTV.
I bumped it back and forth and discovered that I can be a LOT off and still get a rock solid signal with the PLL.
I found the middle point and reset the G-box programming for this new spot.
I got a SOLID, 90% / 70% signal. It was unwavering. Previously it would fluctuate a fair bit.
Question 1 is, is the 90/70 the best signal I can get with a MicroHD ?
Also, I found some new channels on the MeTV transponder. I know they have a backup for the main channel.
Did they also create a backup to Movies! as well? Movies! is now on the frequency that ThisTV used to be on and this unlisted channel is on the original Movies! frequency.
Later I am going to have some questions about how to do a proper C-band alignment but I would need to wait until I have the new meter.
Oh, and on SES-2, are there any old school non S2 signals in the C-band that I can find with my old non-S2 meters? Or is everything on there (in C-band) now S2?
Thanks..
