I have a dish 322 and I can't seem to get the remote to go even 10 feet line of sight. It seems to be getting worse but never really worked right. Today I tried to change the frequency but I couldn't get that to work either. The remote was happy to change to frequency 2 but the receiver wouldn't pick up the change.
At this point I'm thinking the radio in the receiver has failed, but before I spend money on another receiver I thought I would ask the forum if anyone else has had this problem and if a new box resolved it. Another 322 isn't that expensive, but I would rather not drop the $100 unless I know it will fix the issue.
Thanks,
schu
On the TV1 remote press the 'sys info" button....Note the remote address for TV2....If the address is not "1"....Change the remote adress on the TV2remote to the number that appears on the screen..
Before you do this make sure the antenna is connected to the back of the receiver..
Follow these steps....
1. press and hold the "SAT" button until all other buttons light up.
2. choose the number that matches the TV2 remote address number on the sys info screen, press the # key..
3. the SAT button will flash
4. press the record button on the remote
Your remote address now will match the number on the sys info screen.
your remote if functioning properly will now be ready to go..
If it does not work make sure the batteries are fresh..
Anothe little trick..Remove the batteries form the remote for a few minutes then replace them.....
let us know how you make out...