We received our new 522 which is replacing two older receivers. Echostar activated it today. We have a Dish 300 and a Dish 500 which are connected through two DP21 (labeled "SW21-3SAT" in the test switch function) switches. When I set up the 522, I get a good satellite signal through Sat 1 input and a poor/intermittent signal through Sat 2. Mostly there is no signal. If I switch the inputs (move the coax from 1 to 2 and 2 to 1) I get the same result (i.e., Sat 2 is STILL poor/intermittent). I should note that the signal was good on both old receivers.
I unplugged the 522 and plugged back in 10 minutes later and was able to get a signal strength of about 65 on Sat 2. Sat 1 was about 95. When I turned the 522 off and on again, I lost Sat 2 signal entirely.
Can someone help me fix this problem?
I unplugged the 522 and plugged back in 10 minutes later and was able to get a signal strength of about 65 on Sat 2. Sat 1 was about 95. When I turned the 522 off and on again, I lost Sat 2 signal entirely.
Can someone help me fix this problem?