Is there a way to configure the VIP622 to NOT send out video signal (the "Press select to continue" screen saver) when it's in standy mode?
My 622 component video outputs go through a component-to-VGA box. I have another device connected to the passthrough VGA input on that box. The box is supposed to select the passthrough input when there is no signal on the component input, but the 622 ALWAYS sends signal to the component output. Before I start looking at adding more switchboxes, I wanted to see if there was any way to tell the 622 NOT to send signal when I turn it off (standby).
Thanks!
My 622 component video outputs go through a component-to-VGA box. I have another device connected to the passthrough VGA input on that box. The box is supposed to select the passthrough input when there is no signal on the component input, but the 622 ALWAYS sends signal to the component output. Before I start looking at adding more switchboxes, I wanted to see if there was any way to tell the 622 NOT to send signal when I turn it off (standby).
Thanks!