7.5' dish ID and an f/d question

Status
Please reply by conversation.

hags

SatelliteGuys Family
Original poster
Nov 21, 2012
85
0
chain-o-lakes
Picked up this 7.5' mesh BUD locally.

Dug a 12" diameter hole, 50" deep and used 720 pounds of Quickrete mix to secure a 10', schedule 40, 3" galvanized pipe. I picked the pipe up locally from a well drilling/plumbing company for $10, cut to size. After curing, then removing the bracing and checking with a 4' level it is, to my surprise, perfectly plumb.

Any way, I have the dish mounted and I'm ready to set elevation, declination and f/d on the lnb. The only problem is I'm not sure what brand dish this is. From what I can tell it looks like a Unimesh. I see no markings, stampings or scribing on the dish itself.

Can anyone ID this dish so that I can find the f/d setting?


7.5' mesh dish 001.JPG7.5' mesh dish 002.JPG7.5' mesh dish 003.JPG7.5' mesh dish 004.JPG
 
Status
Please reply by conversation.

Basic Linear Actuator questions

Positioner Suggestions? 12' Unimesh on AJAK 180 H-H Mount

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

Who Read This Thread (Total Members: 1)

Latest posts