I don't know for sure what is going on with my dish mover. It keeps getting err2 at times and loses my satellite positions in my microhd. At one point I could not move from one satellite to another without the error. I disconnected it from the microhd and did a complete reset and it seemed to be ok until I hooked it back up to the mhd and it started again. I disconnected from the mhd and reset it and it was ok for a while but it still gets the err2 from time to time but not nearly as often as when it is hooked into the mhd. I have checked the connections and they all seem to be ok. I have a 10' omni mesh dish a powermax vbox-x and new skyjack 18" actuator (less than 6 months old) firmware is 1206 version on the mhd. Any ideas would be appreciated.