Ok so I have a hopper 3 bought a dish 1000.2 bought a hybrid lnb have a separate dish for 129 says please wait while your switch installation is checked. Then removed the 129 from other dish line same thing. Using a DISH NETWORK HYBRID SOLO HUB FOR HOPPER can someone please tell me what to do.
Yes, use the 1000.2 with the WA DPH lnbf. Since that dish doesn't get good line of site to the 129, apparently, you need a 500 (wing) dish for that DP Single or DP Dual - both work fine. Best bet is take a piece of tiin foil and cover the eye on the WA LNBF that's to the left when you're standing behind the dish. That's the 129. Run the cable out of the wing dish to the input port on your DPH WA LNBF. I've had to do this several times. Use port 1 and ONLY port 1 from the WA DPH LNBF to your Hopper 3 - or solo hub if you have Joeys also.
On your Hopper 3, if it's on the installation wizard, hit skip back (Back arrow) - recall - skip back to exit the wizard. Hit the Home button 3 times. Scroll down to #3 - Dish and run the Test Installation. The results will look funky, probably showing 4 columns - 110, 119, X, 129. And it'll take a while to run, but as long as you have all green checks under the 110, 119, 129, you're good to go.
If you need to know where to point the wing dish, post your zip and I'll look it up for you