Got out and hooked it up this morning. According to the instructions, I want a separate line for ku and C. Ku is hooked into the end lnb, works fine for V and H.
C band will only work of the 22K switch is set to off. NOTE - I have the internal 22k switch bypassed on the feedhorn since I have a dedicated line to the 8x1 switch for C band.
My setup is ---- Receiver -> 22K switch outside -> ON setting goes to the 8x1 switch (OFF setting is not hooked to anything) -> port 1 for C band, port 2 for KU.
In order for these to work properly on the old system, 22K on port 1 for C and 22K on port 2 for Ku. Ku is fine, just C is not working at all. I thought the 22K internal was bypassed since the coax is hooked to RCV on the lnb, but it appears it would have to be set to off for me to pick up cband signals.
Did I do something wrong or is there something in the lnb that is messed up?
C band will only work of the 22K switch is set to off. NOTE - I have the internal 22k switch bypassed on the feedhorn since I have a dedicated line to the 8x1 switch for C band.
My setup is ---- Receiver -> 22K switch outside -> ON setting goes to the 8x1 switch (OFF setting is not hooked to anything) -> port 1 for C band, port 2 for KU.
In order for these to work properly on the old system, 22K on port 1 for C and 22K on port 2 for Ku. Ku is fine, just C is not working at all. I thought the 22K internal was bypassed since the coax is hooked to RCV on the lnb, but it appears it would have to be set to off for me to pick up cband signals.
Did I do something wrong or is there something in the lnb that is messed up?