I just had DISH installed this past weekend and I'm a first-time DVR user. I thought I had the DVR-522, but after reading through these forums I may have the 625. I'm not at home right this minute and cannot check. However, here is my setup...I have my receiver set to Dual Mode w/ Record Plus disabled. Both TV1 and TV2 are viewed independently an equal amount of time each day, and this seemed to be the recommended setting. Also, DISH documentation states the following:
Do not change the preference back and forth between TV1 and TV2. This may cause recording conflicts or loss of recordings.
Is this INDEED a problem, i.e. switching back and forth? If so, can you explain further? If this is (or could be) a legitimate problem? If not, it would be nice if there was an option to select TV1 or TV2 each time a DVR timer is created.
Thank you in advance for your reply.
Eric
Do not change the preference back and forth between TV1 and TV2. This may cause recording conflicts or loss of recordings.
Is this INDEED a problem, i.e. switching back and forth? If so, can you explain further? If this is (or could be) a legitimate problem? If not, it would be nice if there was an option to select TV1 or TV2 each time a DVR timer is created.
Thank you in advance for your reply.
Eric