I cannot find the thread that covered this, so I'll start a new inquiry:
What would be the proper way to bypass the pass through on a SG2100 motor?
There was a solution posted here with a splitter, but I never could figure out which splitter was being recommended.
I have to have a long cable between my 4x1 switch & the sg2100 & also have a very long cable between the switch and my Coolsat 4000.
What would be the proper way to bypass the pass through on a SG2100 motor?
There was a solution posted here with a splitter, but I never could figure out which splitter was being recommended.
I have to have a long cable between my 4x1 switch & the sg2100 & also have a very long cable between the switch and my Coolsat 4000.