Hi, I'm trying to setup an fta system with a 33' dish, one Sonicview linear lnbf,
& a new Sonicview 360 Premier. The dish mast is plumb & grounded. I've been
trying to aim the dish to the coordinates to recieve AMC4 101.0 W. @ el. 45.9 & azim. [mag.] @ 137.2 deg. I got this info from dish finder.com , according to my location. All I can get so far with many dish readjustments is a good signal
strength 90+, but always 0 quality level on the setup screen. I also tried
different LNB & transponder settings on the setup screen, to no avail.
I had a small TV & the reciever up on the roof with me While doing all this.
Also, I was using cheapie analog inline db meter & it registered a strong signal
at some points, but still no luck. The logo on the dish front has been spray
painted over, would this matter? I am very new at all of this, any help?
& a new Sonicview 360 Premier. The dish mast is plumb & grounded. I've been
trying to aim the dish to the coordinates to recieve AMC4 101.0 W. @ el. 45.9 & azim. [mag.] @ 137.2 deg. I got this info from dish finder.com , according to my location. All I can get so far with many dish readjustments is a good signal
strength 90+, but always 0 quality level on the setup screen. I also tried
different LNB & transponder settings on the setup screen, to no avail.
I had a small TV & the reciever up on the roof with me While doing all this.
Also, I was using cheapie analog inline db meter & it registered a strong signal
at some points, but still no luck. The logo on the dish front has been spray
painted over, would this matter? I am very new at all of this, any help?